Electronics Forum | Thu Oct 06 18:30:13 EDT 2022 | kojotssss
Solenoids, air flow sensors was checked?
Electronics Forum | Fri Sep 08 22:37:30 EDT 2017 | ttheis
If you have two changers and only one head, make sure there is only one open port (one changer should be filled up and the other should have one open hole.) The head should be full of nozzles as well. As you mentioned go into the diagnostics and act
Electronics Forum | Thu Mar 28 19:23:35 EDT 2024 | linux
replace flow, vacuum sensor
Electronics Forum | Tue Nov 01 20:40:03 EDT 2011 | mikeincal
What may be happening is an early trigger of your vacuum sensors during production due to a clogged tip or vacuum line in the head. What happens during production is that the Y axis gets into position, and then the vacuum sensor input is monitored on
Electronics Forum | Mon May 21 21:31:08 EDT 2001 | Dean
I would like to hear from all Philips Sapphire users about your successes and failures when placing 0402 parts. 1. Are you using type 51 / 57 nozzles? 2. Special vacuum check? 3. How are you calibrating your vacuum sensors? 4. Have you expe
Electronics Forum | Wed Jul 11 14:27:56 EDT 2007 | fredericksr
1) Swapped it out a few weeks ago to attempt to combat the problem ... Great minds eh? 2) I'll try changing the position setting to see if my yields improve. 3) Ahh yes, in fact, I have verified that our vacuum levels are low (range ~130). The
Electronics Forum | Tue Apr 05 14:42:41 EDT 2011 | clampron
Bigvern, We have had the same problem on two different occasions. Both issues were caused by the vacuum sensor. The first time this happened, we had a tech from Dage in to repair. This was fairly costly. When it happened again, we opened the cabinet
Electronics Forum | Tue Feb 15 00:27:39 EST 2011 | jeffr
First clean and de-bur the hole in the nozzle, then try it again. If the Head does not pick up at the feeder, then moves to the dump position...it means that the Vacuum Sensor Board has detected that the nozzle vacuum is above the LOW threshold setti
Electronics Forum | Thu Sep 13 10:49:24 EDT 2007 | slthomas
If someone knows specifically what the sequence of events is in a Topaz placement step I'd appreciate it if you could share that with me. We've developed an intermittent problem with ours where it places the part and immediately stops with E0873. T
Electronics Forum | Sat Dec 12 12:25:14 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
