Electronics Forum | Mon Jul 13 08:12:58 EDT 2009 | cyber_wolf
Does anyone have a source for new Kuroda MDV235-P vacuum valves ?
Electronics Forum | Fri Aug 04 09:48:37 EDT 2023 | boyabandaoti
The pneumatic control valve can be roughly divided into different valves: pneumatic ball valve, pneumatic butterfly valve, pneumatic gates valve, pneumatic intercept valve, and so on. The first two are switching methods of angle strokes, and the latt
Electronics Forum | Tue May 18 08:57:28 EDT 2021 | compit
PS. I bought in China, i'm sure there you will find the right :)
Electronics Forum | Wed May 19 20:45:34 EDT 2021 | compit
The black pad (washer) should be complete with the valve. I have replaced the floppy drives a long time ago :). Software - do you have the optimization of the program in the machine !!! The only thing I use additionally is "PCB Synergy" to import f
Electronics Forum | Tue May 18 08:55:06 EDT 2021 | compit
I bought similar (KOGANEI) for Topaz-X, only the coil of the electromagnet must be the same (voltage). The mechanical part is unlikely to break down - you need to disassember and clean.
Electronics Forum | Wed May 19 20:31:12 EDT 2021 | compit
joy@joysmt.com or from Elissa (I can check the address tomorrow - a person known on this forum).
Electronics Forum | Wed May 19 20:11:21 EDT 2021 | compit
I have two machines - Emerald-X and Topaz-X. I cleaned (and changed Koganei electromagnets) only in Topaz-X - Emerald-X is in very good condition :) But my Emerald-X have SF (not FNC) heads. If head 1 is OK - change the relays with head 2 and check.
Electronics Forum | Thu May 20 22:38:01 EDT 2021 | kumarb
For closure to all readers of this thread...many thanks to Michal for this support. Trans-tec (USA) was great in replying to our countless emails on this topic. We sourced a replacement solenoid # A041E1-48W for our Emerald-X = YV88X. The part was a
Electronics Forum | Mon May 17 10:59:02 EDT 2021 | kumarb
Hi. Have an Emerald-X machine with FNC purchased refurb from Assembleon with mixed results at 3500 hours. Had it sitting idle for years due to assorted issues after their installation. Only now after much time and parts investment have the machinery
Electronics Forum | Tue May 18 09:58:17 EDT 2021 | kumarb
Thank you so much for the advice. We were suspecting blockage but know that we have clean nozzles. Did the air blow out and removed a spot of black matter - perhaps what was an old o-ring? Nozzles are 61 and 62 posing the issue. Our tech said that 64
winsouce.jpg)
