Electronics Forum | Fri Mar 11 12:19:50 EST 2005 | Carmine Garboza
I'd like to see the rotary vane vacuum which could suck up a column of molten tin/lead 2 inches in diameter...
Electronics Forum | Thu Apr 01 14:43:26 EDT 2010 | cbart
You say its in both smt and through hole, but, are you waving the SMT parts as well, I assume yes since you think its dross in the joints. Questions: 1- do you have higher mag scopes that you can zoom in a little more to see if these are voids or dr
Electronics Forum | Tue Mar 29 03:03:42 EDT 2016 | wesleyintelli
Our MPM UP100 is not slowing the pcb carriage as it is brought under the stencil. The result is that the carriage jolts the machine heavily when it is fully loaded. The hall effect vane sensor half way along the rear rail is working correctly. The le
Electronics Forum | Thu Mar 18 09:25:27 EST 2004 | remullis
Normally when I run into having to hit the ESC key to step through this is the steps I take. 1. Power machine down and restart. 2. Home machine and watch cutter carefully. Both cutter should acuate and the height motors should run CW and CCW. 3. You
Electronics Forum | Fri Mar 28 15:08:37 EDT 2008 | jmelson
Hello, all, I have been having problems with bent push rods on my Philips CSM84. I have caught it a couple times when it happened, but it happens so fast I still don't know exactly what the sequence is that causes this. The push rod is clipping a
| 1 |
winsouce.jpg)