Electronics Forum | Fri Dec 18 12:45:23 EST 2015 | deanm
Using a vapor degreaser with a solvent such as Vertrel, Novec, Techspray 1655, Solstice, etc. may work for you but solvents can attack certain plastics. Should be fine for SMT though. This is assuming you are using a no-clean (RMA) type flux, not wat
Electronics Forum | Mon Aug 31 16:30:01 EDT 2020 | emeto
I would question your motive "There's no way that I feel comfortable shipping boards after a selective without cleaning them, the amount of flux on the board is significantly more than from SMT". 1. Who said that residue should be cleaned and why? O
Electronics Forum | Thu Sep 03 01:15:52 EDT 2020 | kylehunter
> The problem that we have seen applying NC flux > (EF2210) at selective solder is that the flux > overspray (relative to the nozzle path) did not > see high enough temperature to activate the flux > and turn it to a non-conductive
Electronics Forum | Thu Sep 03 21:49:20 EDT 2020 | kylehunter
> Not in our case, the pre-heat temp was not high > enough. Also our pre-heat is only from top > (KISS104). Ahh that makes total sense. We have bottom IR, and have thermocoupled at 100c, so I think we should be good on that end. Anoth
Electronics Forum | Wed Aug 27 13:11:19 EDT 2008 | dwelch123
We roll ours up, fingers and all, and soak them for about an hour in a solution of water and DOMINATE (heavy duty degreaser) you can order from Grainger. They come out looking brand new every time!
Electronics Forum | Tue May 15 21:57:06 EDT 2001 | davef
Welcome!!! Where the hay ya been??? Sorry bud, were lining-up with your fab [it hurts me to say that, but when yer ] We used to dry pack with desiccants, also. Its probably an old MIL-STD-2073-1C requirement [er something like that]. We qui
Electronics Forum | Mon May 21 17:32:23 EDT 2001 | davef
I said: "Our electronic circuit board fabricators seal the boards in moisture barrier bags [MBB]. We discontinued the use of desiccant bags in these MBB because of concerns about the desiccant releasing materials that would affect the solderability
Electronics Forum | Tue Jan 10 20:39:06 EST 2006 | aqueous
Of course there are solvents which are less harmful to the environment than others. The operative phrase is �less harmful�. As a rule, water-based chemistries are �greener� than solvents. There are some solvent blends designed for aqueous-based eq
Electronics Forum | Mon Aug 31 16:55:48 EDT 2020 | kylehunter
> I would question your motive "There's no way > that I feel comfortable shipping boards after a > selective without cleaning them, the amount of > flux on the board is significantly more than from > SMT". 1. Who said th
Electronics Forum | Mon Nov 27 17:50:01 EST 2000 | Dave F
Mike: It gets more humid in the winter? [I can see it�s true (not that I�d doubt you) cause I�m looking a a humidy map of the USA, right now] How does that work outin Californy? [Do the ocean breezes move the humid air in-land in the summer? Er w