Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Wed Aug 24 09:20:25 EDT 2016 | dekhead
Suspect comms link error from Y3 to Y1 crate. COM 2 off of CPU, depending on board. If CPU board has RS485 port it is direct to back panel of PC; if older board it only has RS232 and thus requires 232/485 converter board (internal to PC). then direct
Electronics Forum | Thu Dec 24 12:43:18 EST 2020 | marcelorotofrance
Hi Bob. When I initialize the system, all functions appears. In "Utilities/Initialize System Comm" option too. I have to confirm yet, but this problem appears to not happen in all programs. The red error message shows when I launch the program. My su
Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Sat Sep 16 15:47:08 EDT 2006 | dekhead
95% possibility to the ballscrew... which is no ones favorite to replace. As far as the table situation now. I'm guessing that you have verified that the motor has power and the brake is not engaged. Does it still give a position error? or does it g
Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Wed Dec 07 14:20:29 EST 2005 | Robert
I had a DEK 265LT with error code: motor comms failure.card 1, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 1 and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, Rober
Electronics Forum | Thu Apr 18 15:33:37 EDT 2013 | empac
Hello, Does anyone know how to fix the following problem on a DEK265GSX? Motor comms failure card1 AX123 Fatal error re-initialize machine. Appreciate your help! Bob
Electronics Forum | Thu Dec 24 14:52:24 EST 2020 | bobpan
Good job, For the comm errors i would try: 1. Reseat all the cables that plug into the white multiplexer that is attached to the back of the computer. 2. Reseat the EPCU card down inside the machine. good luck, Merry Xmas, Bob
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
