Electronics Forum | Mon Aug 19 02:32:37 EDT 2019 | hemantpang23
Thanks for reply, please help to identify other possible reasons of this error
Electronics Forum | Fri Sep 06 16:48:01 EDT 2019 | linux
Change SCU card with next module, reboot. Zero set Send proper
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Fri Aug 07 18:09:55 EDT 2015 | bnorton
The power distribution board has 10 green LEDs on. By the time of the error SysFail is still on. Logicomm connected to the Force board COMM2 shows a stream of messages saying "Lantern system not active. Heart Beat = 0"
Electronics Forum | Fri Mar 05 08:06:39 EST 2010 | rgduval
Rob, Had that issue early on when we hooked up our Heller. For us, the problem turned out to be the serial communications port on the computer. I can't say we had the black screen, but, we had comm errors. I'd check the following: 1. Cable betwe
Electronics Forum | Wed Aug 12 11:01:37 EDT 2015 | bnorton
Machine->Config and set all their addresses to 0. We have swapped the EPC5, the VGA Video, the Force board, and most recently the Lantern 630VME. Watching the Force board COMM2 with Logicomm, at the end of all the ldx file processing it changes to c
Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Wed Aug 24 09:20:25 EDT 2016 | dekhead
Suspect comms link error from Y3 to Y1 crate. COM 2 off of CPU, depending on board. If CPU board has RS485 port it is direct to back panel of PC; if older board it only has RS232 and thus requires 232/485 converter board (internal to PC). then direct
