Electronics Forum | Mon Aug 23 12:06:37 EDT 2021 | mk15
Hi, I am looking for a an Electrical Service Manual for a Universal Universal sequencer vcd 6241d. thanks
Electronics Forum | Mon Aug 23 13:39:25 EDT 2021 | charliedci
Try Dan at swuicsup@yahoo.com. He carries parts and knows these machines well.
Electronics Forum | Fri Jan 29 10:53:13 EST 2010 | jeffharley
There are pots on the board in the power supply to adjust the voltages after the machine is powered up. The location of these pots are in the munual supplied with the machine
Electronics Forum | Fri Jan 29 12:59:47 EST 2010 | remullis
Something on the 5v side is pulling it down. I would check every thing associated with the harness you are disconnecting. Your shorting somewhere! Don't have a schematic in front of me. Also look for leads getting into the backside of your connecto
Electronics Forum | Wed Feb 03 18:29:46 EST 2010 | mika
4.85 V - 5.2 Volts. That is on the computer power inlet, Not the on the power supply. /Best Regards
Electronics Forum | Mon Jan 25 17:13:53 EST 2010 | bing007
I am working on a vcd 8 with a problem of loosing the 5 volts supply. We have fitted a new supply that also provides the 15 volts. When we remove the connector on the power chassis for the 5 volts the power supply shows OK. When fitted the 5 volts is
Electronics Forum | Mon Feb 01 14:04:12 EST 2010 | bing007
Found the problem. Thanks for the pointers. I had set the voltage to 5.00 volts as it was reading 4.86 volts. I still had the problem. A slghtly burnt wire going into the spade connector on the back of fuse holder 12 (5 volts). The reason the voltage
Electronics Forum | Fri Apr 24 11:00:36 EDT 1998 | Francisco Becerra
I have a problem with the insertion tooling of a 6241B VCD Insertion Machine. I must replace most of the parts of the insertion head but the screws of the Rails has the socket head damage, so it is not possible using the Allen Tool. I am looking for
Electronics Forum | Fri Apr 24 10:59:59 EDT 1998 | Francisco Becerra
I have a problem with the insertion tooling of a 6241B VCD Insertion Machine. I must replace most of the parts of the insertion head but the screws of the Rails has the socket head damage, so it is not possible using the Allen Tool. I am looking for
Electronics Forum | Tue Jan 08 09:32:58 EST 2008 | nemachines
Hello We can supply all universal spare parts, you can contact us direct with your enquiry. www.northeastmachines.com Thanks
