Electronics Forum | Wed Aug 14 10:11:01 EDT 2002 | davef
For relow ovens the general approaches are: * Clean the vent pipe. * Replace [a section of ] the vent pipe. * Clean the flux trap on newer ovens. * Do nothing and wonder where that brown slime that is dripping on the boards is coming from. For wave
Electronics Forum | Wed Jan 20 14:28:50 EST 1999 | Dave F
| I have a severe problem with flux residue being drawn up the vent ducts of my reflow oven. This residue reaches a critical mass then begins to flow down the ducts and becomes very messy. I run a no-clean process and use IR oven. Has anyone else o
Electronics Forum | Wed Jul 11 22:46:32 EDT 2012 | davef
Several points are: * There can be a seasonality to the venting of [smells emanating from] wave solder machines, because the heating and cooling of your plant changes with season. * Supplier's specification for your wave solder machine defines the pr
Electronics Forum | Wed Dec 18 10:25:45 EST 2019 | dwl
I worked at a similar sized facility in Texas, and we had everything connected to one vent and exhausted outside. A word of advice; Your outside vent will leak in heavy rain, don't put it over any equipment.
Electronics Forum | Fri Jan 12 14:05:33 EST 2024 | rygenetic
Hi @calebcSMT, It is generally recommended to avoid coating the entire body of aluminum electrolytic capacitors. These capacitors rely on the venting of gas in case of failure or overvoltage conditions, and coating the entire component could hinder
Electronics Forum | Thu Aug 05 10:13:44 EDT 1999 | Boca
| We are installing a new reflow oven and I have been told that we do not need to vent the exhaust out through the roof since we have a false ceiling. All that is required is to vent above the false ceiling and that the air exchange is great enough t
Electronics Forum | Sat May 03 14:06:25 EDT 2014 | jyo_409
What are the possible reasons for electrolyte leakage What is the purpose of the vent in the capacitor? Why vent is not being maintained for all types / values of the capacitors? What is the significance of the end seal configuration. Why end seal co
Electronics Forum | Mon Aug 19 04:08:04 EDT 2002 | lloyd
No. My ovens are vented on a seperate system. Any other ideas.
Electronics Forum | Wed Aug 21 17:48:55 EDT 2002 | davef
No, you should expect to globs of stuff that is a bit reminiscent of chewin� �backee on yer boards.
Electronics Forum | Mon Sep 20 16:06:53 EDT 2004 | blnorman
We require that the ovens used for bake out are vented, thus removing the vapor from the oven.