Electronics Forum | Mon Sep 09 11:02:45 EDT 2002 | mk
No change in Vendor. Here is some additional info from this morning, There are no shorts, opens, or visible defects. The problem is that when the boards are ICT'd, the values of the resistors, caps etc are measuring out or tolerance????? Can the go
Electronics Forum | Mon Sep 09 09:30:25 EDT 2002 | ksfacinelli
Did you switch board vendor?
Electronics Forum | Wed Nov 23 11:27:32 EST 2005 | jrlouden
Are there any pros or cons in regards to jars or cartridges for sodler paste dispensing and handling?
Electronics Forum | Sun Jan 23 22:01:13 EST 2000 | Bill Schreiber
The Web Site URLs are: NEPCON West: www.nepcon.reedexpo.com/west/show/index.htm APEX: www.apex2000.org We are favoring NEPCON West since it is a proven show. However, Thomas' idea to visit the web sites and decide for yourself is the way to go.
Electronics Forum | Mon Aug 03 12:33:19 EDT 1998 | Dew Lolly
I and I imagine most of you, are embroiled in the turf war going on between CIMBridge and Unicam. Since Fuji is squarely in the center of this issue I would imagine that many of you are wondering which way to lean. I'm wondering if we are not going
Electronics Forum | Tue Aug 04 10:04:08 EDT 1998 | Wayne
Dew: Is this the third or forth software alignment for Fuji? Hope they stick with Unicam for a period of time... Just my two cents....
Electronics Forum | Mon Sep 09 10:50:24 EDT 2002 | bmulcahy
Hi MK, It not really as simple as changing from one to the other. VIA hole, PTH hole sizes may need to be changed. Really the designer should re-evalaute the board before changing. Also remember your soldering profiles, both reflow and wave (if appl
Electronics Forum | Mon Sep 09 11:20:50 EDT 2002 | ksfacinelli
I have never seen that occur when using gold plating vs. HASL. I am a big fan of the gold process and have achieved very consistent quality. Did the board vender do an impedance measure to validate you design?
Electronics Forum | Wed Sep 11 14:11:59 EDT 2002 | blnorman
We had a similar problem with components being out of spec, course our problem was that they were coming in out of spec, not being damaged by our process. Do you do any incoming inspection?
Electronics Forum | Wed Sep 11 15:49:10 EDT 2002 | stepheno
Are you no clean or WS? Have you used a MultiMeter to verify the ICT failures? Maybe the components are fine but the pins are contaminated. Or the test points. Don't have any reason to suspect that due to HASL vs gold. It's just I don't trust data o
