Electronics Forum | Fri Dec 01 15:22:46 EST 2017 | kojotssss
Recommended land and solder pattern says: VIA wall plating, via holes should be tented with solder mask on the backside and filled with solder. Solutions at this moment ? Thanks for all :)
Electronics Forum | Tue Aug 22 14:52:55 EDT 2000 | John Thorup
Jax - absolutely right - the archives are a valuable tool and deserve to be used more than they seem to be. Caumel - Are your blobs on the solder side or the component side? Are your vias tented on the component side? What size are your vias? Is th
Electronics Forum | Wed Sep 27 19:37:32 EDT 2000 | Dave F
Wolfgang is correct. Copper plating thickness of the via barrel walls is a key question you need to answer to troubleshoot this. Tenting is a red herring.
Electronics Forum | Thu Nov 22 12:56:12 EST 2001 | tony_sauve
Thanks for the comments & suggestions. Here's some info garnered from a telecon w/the PCB Fab house: -the blind via's extend from layer 2-17...this was a revelation. The info from our customer was that the via's only extended down 2 layers. Did I men
Electronics Forum | Thu Oct 08 14:04:04 EDT 1998 | Kris Ewen
Manish, I've seen similar phenomenon when processing CSPs on our cards. In our case, we were placing the components over the opening to in-pad blind vias. Due to poor drilling and plating processes by our board suppliers, volatiles were outgassing
Electronics Forum | Mon Oct 31 13:31:19 EDT 2011 | davef
We're not sure what a 'sticky roller' is, but will it: * Remove ionic materials * Leave no residue * Clean the walls of through holes and vias * Clean under low stand-off BGA and LGA
Electronics Forum | Thu Jul 05 19:39:19 EDT 2001 | davef
I had forgotten that it was you that was on the Sipad adventure. [But then again, who can keep track of yer aliases? ;-)] You just go from one adventure to the next. Expanding On Dave�s Hi-Test Flux Method Theory � PASTE: Yes, contact your favorit
Electronics Forum | Wed Apr 21 17:11:05 EDT 1999 | Earl Moon
| Does anyone have any experience with soldering 50mil pitch BGA's that have a via in the pad, the size is .012 The via will be masked off on the bottom side of the board. Need to know what precautions or problems if any I might encounter. The proces
Electronics Forum | Wed Apr 21 19:09:10 EDT 1999 | Earl Moon
| | Does anyone have any experience with soldering 50mil pitch BGA's that have a via in the pad, the size is .012 The via will be masked off on the bottom side of the board. Need to know what precautions or problems if any I might encounter. The proc
Electronics Forum | Thu Oct 30 23:39:10 EDT 2014 | beilimanu
No paper thing, while I can make some suggestions based on my experience. what is the size of your via? If it's smaller than dia0.4mm, in PCB production process it should be filled by soldermask. So my suggestion is design it to be full filled by SM
.gif)
