Electronics Forum | Fri Oct 01 00:49:33 EDT 2010 | darrenj
Yes, we have the Agilis stick feeder and it is a definite improvement on the vibe. It usually comes with a set of starter 'tubeforks', but i bought another starter set after a while since the individual tubeforks are relatively expenisive. Always g
Electronics Forum | Fri Jun 04 14:04:36 EDT 2010 | dedwards
I have a question about assembleon vibration feeders. What is the process for loading tubes in these feeders? Our personnel are cutting the top of a tube end around the size of the part and glueing it into place. Then the machine is programmed for
Electronics Forum | Sun Aug 07 14:37:50 EDT 2011 | franxsmt
Hi every body, Recently I got a vibration feeder for my SM421 Samsung machine. The feeder has no manual and I don't have any contact with Samsung people. I put the feeder into a feeder slot, the feeder goes on (a red lamp on the feeder indicates it
Electronics Forum | Thu Jul 28 08:16:33 EDT 2005 | grantp
Hi, Your not using vibration feeder here are you? I have seen this a lot with vibration stick feeders. Regards, Grant
Electronics Forum | Sun Aug 07 17:50:49 EDT 2011 | kahrpr
Samsung website dynatech if in usa http://www.samsung-smt.com/customer/saleservice.asp#mapArea
Electronics Forum | Mon Aug 08 07:45:23 EDT 2011 | geb
Although I don't have the same model machine (ours is Samsung CP45FV) our Vib feeder had a "transportation" screw or strap (it was a few years ago) fitted that you need to remove before it vibrates properly. Ours has a on/ off switch on the feeder
Electronics Forum | Mon Aug 08 10:27:48 EDT 2011 | franxsmt
That's it!!! Thank you GEB! Actually the "transportation strap" seemed like a main part of the feeder, so I would never come to the idea to remove it. Now it vibrates like a rattlesnake's tail! Thank you very much for the tip. F.
Electronics Forum | Tue Oct 07 11:03:07 EDT 2014 | dyoungquist
The new stick magazine he references is the ASM (Agilis Stick Magazine). I have experience running both the vibration mags and the ASM. The ASMs are far better than the old vibe mags. You may have to upgrade your TPSys software to use the ASM but
Electronics Forum | Sat Sep 27 19:47:21 EDT 2014 | cyle
Reels are 100% the best, vibration feeders should always be a back up, they are quite unreliable through no fault of their own. Say you have 1000 parts to be placed, and the cost of a reel is 100$ more than a tube, but the reel loads 10 to 1 over th
Electronics Forum | Fri Sep 26 16:02:28 EDT 2014 | heath
Hello all, I'm curious to hear how successful others have been with vibration feeders on their pick and place machines. We have a MY12 and a major source of consternation comes from parts not shaking down to where they can be picked up. The variab
