Electronics Forum | Tue Aug 04 13:45:56 EDT 2009 | pauld
Unable to access older Forum threads. "Internal Server Error The server encountered an internal error or misconfiguration and was unable to complete your request. Please contact the server administrator, root@localhost and inform them of the time t
Electronics Forum | Wed Aug 26 06:41:24 EDT 2009 | davef
Here's another example where the posts do not order, sequence properly: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=59600 Actually this thread is another example. The top-most post was a response to the following post: Date: August 0
Electronics Forum | Fri Jul 31 10:02:12 EDT 2009 | spitkis2
Thanks for the info. On the Mydata do you position the cut tape inside a feeder or place it on a tray of some sort? Here the environment is OEM R&D lab so a Mydata would be overkill in terms of size and cost. I was thinking of a smaller auto pick
Electronics Forum | Fri Jul 31 12:53:58 EDT 2009 | dyoungquist
On our Mydata machine, we place a piece of scrap bare pcb next to the pcb we are loading. Using double sided tape, we attach the cut tape strip to the bare pcb, then program the machine to pick up the parts from that location. The smallest Mydata m
Electronics Forum | Mon Aug 03 15:49:31 EDT 2009 | gtemkin
Sounds like the Pin in Paste would be a reflow technique not involving a pot. I'm guessing however the same causes are in play, in that the poorer wetting of the Pb-free allow means it drops out of the joint before it can wet to the terminal. We us
Electronics Forum | Fri Aug 07 15:56:56 EDT 2009 | davef
Well, since you've gotten no takers, we'll launch in to this with careful analysis and introspection, fully aware that we're likely to get 'blasted' for any number of reasons. The most critical parameters to monitor for proper wave solder machine pr
Electronics Forum | Tue Aug 04 03:54:04 EDT 2009 | rafacadiz
I would like to perform a Solder paste height capability study. I will apreciate any info about and what equipment use to measure the height of the solder paste. I only found the attached equipment. Solder Paste Height Measurement System (SPM-300-3D
Electronics Forum | Thu Aug 06 17:56:29 EDT 2009 | stevea
Don't forget about ASC International. Having the largest supported installed base of benchtop SPI systems in the world, I'm surprised we were missed. If you have any further questions, I woudl be happy to assist. We have performed hundreds of test
Electronics Forum | Fri Aug 07 02:18:52 EDT 2009 | emanuel
I sent them a couple of emails a while ago. Both were replied with an automatic answer saying they will reply soon. The 1818 is not on the list of supported models, according to their announcement from Sept.2007, the 1818 is replaced by the FX/D. I
Electronics Forum | Tue Aug 04 23:23:01 EDT 2009 | gopang
I have problem with my Panadac 770, the problem no out Put 5v, i was check : 1). Change SMPS in panadac 2). Change terminal cad 3). Change Transistor 2SC2200 4). Change transistor 2SD867 Please conform to me if have solutions and some body have wir
