Electronics Forum | Mon Mar 25 10:22:20 EDT 2013 | rgduval
You mentioned that you changed the layout some, and this can be essential in this type of process. If the SMT parts and TH leads have inadequate spacing on the bottom side, shorts may be inevitable (someone else will have to advise what the recommen
Electronics Forum | Wed Jul 10 19:17:06 EDT 2013 | m20lara
Hello all. I was hoping that maybe someone has a > manual for a Omniflo 5. Build year is 1998. > Photocopies would be greatly appreciated, and > willing to pay. Even if we could put down a > deposit, you send the manual we do the photocopy > and
Electronics Forum | Mon Apr 01 17:20:45 EDT 2013 | davef
In thinking about troubleshooting tombstoning {TS} defects, seek balance: * Pads the same size * Same amount of paste on each pad * Component placed with the same amount of contact on each pad * Heating the same on each pad, no via connection to a gr
Electronics Forum | Wed Apr 24 09:20:08 EDT 2013 | eadthem
O also registering the machines so you can get support is very wise, Universal has a amassing support network, least of all is phone and email support. Also sense you are new to the machine, a week trip to new york for training in programming an
Electronics Forum | Mon Apr 01 08:09:36 EDT 2013 | babe7362000
We currently have an AOI after reflow, and I was wondering how others have thier line setup? Does the AOI operator have to get up and get a board from the oven to run, or should the SMT operator hand the AOI operator a board. The AOI operator does
Electronics Forum | Mon Apr 01 13:47:38 EDT 2013 | microaide
Anyone know how to use AutoProgram 5.32 for the Quad IVc assemblers? I am having all kinds of problems. I can't create a new SMD Type because the Edit menu is greyed out, so I can't select New. I can't figure out how to set up feeders and assign feed
Electronics Forum | Mon Apr 01 17:02:58 EDT 2013 | microaide
Yes! Thank you. That was not intuitively obvious, nor did the manual make that point clear at all. I can now create new SMD Types. Now if I just had the foggiest idea on how to set up and assign feeders, I might be able to generate my program. Right
Electronics Forum | Tue Apr 02 13:08:40 EDT 2013 | babe7362000
It has been years since I used autoprogram. But I believe your low reference number is your low slot number on the base and then the ref. is what slot you will teach your feeder ref. to the far left. And the High slot number is the higest slot numb
Electronics Forum | Tue Apr 02 17:22:50 EDT 2013 | microaide
That makes some sense. By knowing the coordinates of the leftmost and rightmost feeder, the others can be interpolated. As long as they are all the same type of feeder. But I still don't see how to configure an assortment of different types of vibrat
Electronics Forum | Fri Apr 05 14:17:11 EDT 2013 | leemeyer
I have no idea why this limitation would be programmed in. Like I said before there a lot of wierd quirks whith this software and you may have just found one. Pre-assigning will not help if the software sees a mismatch between the feeder plate and th