Electronics Forum | Thu Aug 29 15:09:23 EDT 2013 | bvdb
Hi, Yes, there is a board marked "Memory Board" but it does not actually contain any memory. The memory card is attached to the CPU card. The board marked "Memory" is a board that allows you to plug in a Compact Flash (CF) memory card which we do
Electronics Forum | Fri Aug 23 00:27:07 EDT 2013 | comatose
I have an AP25 printer, which has served us fine for years. A couple days ago the top quarter of the vision display went all "wiggly" and now it won't find fids. The PC and monitor are fine, so its definitely something in the vision system. Before
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Fri Aug 30 11:31:29 EDT 2013 | nophsem
We have two QUAD 4C working in tandem. 3 months ago the EPCU battery (QUAD # 2) died, then we change it. Then downloaded the MODs from the controller to the assembler(does simultaneously on both machines). All this time we continue to work normally.
Electronics Forum | Tue Sep 03 05:37:06 EDT 2013 | bobpan
It sounds like your dispenser has a problem....The default mod code for 56 is 0 (this should be off). Thats why when you cleared the mod codes the machine was able to home. When you reload your saved mod codes it is probably set to 1. The machine wil
Electronics Forum | Fri Aug 30 22:14:58 EDT 2013 | isd_jwendell
I have used the 850's previous version (and other batch ovens). The current specified was AFTER the unit was at operating temperature, not what it took to warm up. If you have power restrictions, like I do, be careful with this model. Having used ba
Electronics Forum | Fri Aug 30 22:51:14 EDT 2013 | cvogel
IPC-J-STD-001E in regards to Ionic Cleanliness standards states less than 1.56 µg/cm² of total NaCL. Assuming a typical electronic process which involves smt, wave, and post-hand soldering and uses NO-Clean flux throughout all process, is it typi
Electronics Forum | Thu Sep 05 22:33:28 EDT 2013 | davef
It depends: * If you're talking jars, I'd be as conservative as possible. So, 3 days from when the jar is removed from the frig would be my pot life limit. * If you're talking Semco cartridges, I'd be talking about 10 days from when the cartridge is
Electronics Forum | Wed Sep 04 11:37:30 EDT 2013 | trice1212
Afternoon SMTnet forum users, The Assembleon Opal-XII we use has been showing an error when ran at 100% speed. We talked to the tech in AZ and he believes we have a problem with our y-motors. We turned the speed down and haven't had the problem com
Electronics Forum | Fri Sep 06 14:03:18 EDT 2013 | horchak
If you are a CEM you are setting yourself up for failure and will be left holding the bag. Flash gold has one purpose. It is a protective coating for the base medal to keep it from oxidizing. It is very thin and will be absorbed into the solder joint
