Electronics Forum | Wed Mar 19 08:38:13 EDT 2014 | davef
I can't picture much of what you're saying, not for nothing, I'm just not connecting. During assembly, solder mask can affected by heat and chemicals. Typically this would be during: * Soldering * Cleaning I will tell you this: Not to defend assem
Electronics Forum | Tue Mar 25 13:55:05 EDT 2014 | horchak
Ok lets put it this way. If the PCB house used a high quality mask and properly applied it to a properly cleaned surface and properly cured it, then as Dave stated above there are only two things that can destroy it. Excessive heat and overly aggress
Electronics Forum | Wed Mar 19 12:36:04 EDT 2014 | joeherz
We have an application where an assembly has to be residue (flux) free except for 2 SMT non washable parts. Currently those parts are post wash hand adds but the product volume is exploding. We want to run those parts in SMT, mask them using an aut
Electronics Forum | Thu Mar 20 11:30:58 EDT 2014 | dave222
Hello Again. I little more information about the issue: when trying to zero machine head the spindles move up and down about 6 times before giving the error code. also I notice that all the LEDs on the circuit board are off. L11 - L18. and the nume
Electronics Forum | Thu Mar 20 17:26:14 EDT 2014 | dave222
I tried to check for the emitter and the receiver and I notice that the receiver is screwed into the side of the head and not easily accessible so I decide not to mess with it. this is what I did. I activated all of the clutches for the spindles an
Electronics Forum | Tue Mar 25 02:58:24 EDT 2014 | molder
ok.. thanks you so much.. I will buy new dispenser siringe, and I try to rework... I have a questions on desolder and solder a socket 1366 intel on motherboard. I have a rework station Honton hot air and tornado infrared, but i don't know a temperatu
Electronics Forum | Tue Mar 25 15:16:16 EDT 2014 | yuran111
machine controller BIOS loads only cyclically until pressed reset button on it - now checks the configuration and loading tasks load. hard drive I can take from the controller Siemens s27 example? motherboard came from s27 machine, and the same softw
Electronics Forum | Thu Mar 27 08:23:37 EDT 2014 | emeto
Hello, we have several generation of Siemens machines and one of our lines is ASM SX1 series. Machine is very accurate and reliable as a hardware, but in my opinion the software is their biggest advantage. Software is very powerful and can do things
Electronics Forum | Mon Mar 31 14:52:02 EDT 2014 | jax
Both Manufacturers and Machine Types are a good choice... Why just these two Manufacturers? Depending on your needs (Changeover times, Board Size, Part Size, Part Counts, Odd Form requirements, CPH requirements, and the list goes on), there might be
Electronics Forum | Thu Mar 27 18:07:02 EDT 2014 | hegemon
If you are 100% sure that the solder has reflowed (time and temp based), then just use an wood stick to wedge the part upwards. It just takes a little bit of "lift". I used a wooden Q-Tip end that I trimmed to a wedge using an exacto blade. Wait f