Electronics Forum | Sat Jan 18 12:03:54 EST 2014 | jimmyboz
Hi, > > My FUJI CP65 is working last couple of > month. Last week, it display "Hardware NG" > message when I power on. I can not find this msg > in the manual. Does anyone has experiences with > this to point me where I should > look? Thanks, -
Electronics Forum | Mon Jan 20 11:07:18 EST 2014 | jorge_quijano
Hola We will start producing flex cables soon for a new project, we've never built them in house, we have no experience in this field, most of our products are PCBA & Backplanes. I'm guessing that I can run this cables using a fixture to secure the s
Electronics Forum | Tue Jan 21 13:43:12 EST 2014 | rgduval
Jorge, Your description of the process sounds about right. A fixture to hold the flex cable taut (and in a repeatable location) that allows you to paste/place/reflow is essential. As for notes: Be hyper aware of moisture/humidity in regards to
Electronics Forum | Tue Jan 21 09:39:56 EST 2014 | spoiltforchoice
http://www.graphicode.com/GC-PowerPlace this does, I had a dabble and while it does seem quite capable the learning curve is quite steep and I'd wager the price is too. As with GCPrevue, the user interface is hardly what you would call streamlined or
Electronics Forum | Sun Feb 16 05:57:02 EST 2014 | alexeis
Hi, From our experience, Gerber files are accompanied by IPC type files. These files usually have extensions: IPC, NET, 356. We have developed products that are designed to help in programming part of the SMT machine, based on these files beyond sta
Electronics Forum | Fri Oct 30 19:37:26 EDT 2015 | sarason
If you want to go down this path there is a piece of free software from a dutch programmer called Visualplace. It is available here. http://www.compuphase.com/visualplace/visualplace_en.htm If you want to work from CAD files there s my sofware call
Electronics Forum | Sat Feb 04 10:02:53 EST 2017 | mikekeens
GC-PowerPlace from http://www.graphicode.com/ will do this but takes time to get to grips with and can be time consuming depending on the design complexity and the type of data available. Ideally i recommend asking for CAD data as this will contain
Electronics Forum | Wed Jan 22 14:25:17 EST 2014 | rgduval
In the purest sense of ESD control, we would have to say yes, use ESD tape to cover the gold fingers. The gold fingers are connected directly to input/output controls for the card, and, as we all know, when handling boards, we're supposed to avoid c
Electronics Forum | Fri Jan 24 16:54:24 EST 2014 | davef
Yeh, I worked at Wang Computer factory in a reclaimed fabric mill with wooden floors. One of the causes of grapping is flux loss. In their paper, Briggs and Laskey talk about flux loss due to spreading and suggest: * Graping is much less prevalent i
Electronics Forum | Wed Jan 29 10:23:24 EST 2014 | alphatronique
Hi i have strange issue on one of my TM8FC feeder feeder seem to have 0.5 to 1mm longer that my other feeder on image above have 2 side by side picture was take on same machine slot ,and both feeder have same part separation clip i even swap cl
.gif)
