Electronics Forum | Wed Jul 08 00:12:20 EDT 2020 | duchoang
Interesting!. They don't look like voids as usual meanings. The "voids" take the whole size of pads. We built millions of BGA, never seen those before. Look like the pads refused to connect with solder paste and pushed the paste away. Pads contaminat
Electronics Forum | Wed Jun 17 18:38:21 EDT 2020 | dilogic
Blue rectangle on the screen is actual search area. Green cross points excatly to the component centroid how vision system determined it - so, your component was picked slightly off center but still within the range. Now, the reason for offset can be
Electronics Forum | Wed Jun 24 15:36:58 EDT 2020 | aveazey
Do you know which menu this is under? We had tried changing the X,Y Location in the Camera configuration but the changes didn't seem to actually change anything. We would power cycle the machine every time after changing the config file. We also trie
Electronics Forum | Thu Jun 25 10:51:08 EDT 2020 | kumarb
How long have these devices been out of their sealed dry packs? Did you receive the devices factory new or from a broker of such parts? What may be happening is that moisture crept inside the device and there requires the parts to be baked before you
Electronics Forum | Wed Jun 24 14:10:01 EDT 2020 | stephendo
When I was looking into it previously it looked like you could pay a large fee and have your paperwork audited. I didn't find having auditors coming in and checking that you were actually following your paperwork. Having your ESD S20-20 procedures au
Electronics Forum | Fri Jun 19 17:09:11 EDT 2020 | jmelson
The Eclipse really looks like it would do everything I'm doing now very well. I'm not too clear on how well the laser/1D vision would work for QFN parts, but maybe it would be fine. The downside is I think these machines are now going to be hard to
Electronics Forum | Mon Jun 22 01:49:27 EDT 2020 | vinitverma
I too would advise against converting a 3-phase machine to single phase. Eclipse is a single phase machine and not too difficult to find! It's a rugged machine and people still use them. Orion too is single phase but faster and less accurate than an
Electronics Forum | Fri Jun 26 01:33:32 EDT 2020 | jmelson
> why not get an older essemtec or neoden? I > believe both run on 110V. Thanks so much for the Essemtec hint! Their Fox 1 really looks like it suits my needs! 18 mm component height, 50 um accuracy, small size, what's not to like? I'm go
Electronics Forum | Sat Jun 27 01:10:06 EDT 2020 | jmelson
> Finding one used could be <BR> > the first challenge, the Fox is a 2016 machine <BR> > the second issue will be the price. Yes, after some research I realized the Fox is a relatively new model, and is going to be o
Electronics Forum | Mon Jun 29 15:25:09 EDT 2020 | jmelson
Spoilt, OK, a good point in your message, what good is a machine with 15 mm component height capability if there are no feeders that support that tall a component! I hadn't thought about that aspect! (My Philips CSM84 is limited to 6.5 mm, and I r