Electronics Forum | Fri Jul 10 15:28:47 EDT 2015 | sumote
I could really use some help, My oven is continually blowing one of the SFC fuses (the one on the left as it sets in the machine) when the conveyor tries to run. It appears that the traces on the circuit card were having too much current pulled th
Electronics Forum | Sat Jul 25 18:35:33 EDT 2015 | orbitcoms
I am looking for information regarding setting up an SMT assembly line. I have recently purchased a stencil paste printer, pick and place, and reflow oven. The main information I need is the paste selection and best finish material on the PCBs. I wil
Electronics Forum | Sun Jul 26 07:09:25 EDT 2015 | orbitcoms
Thank you for your prompt response. The boards we have made for us current are Immersed Gold treated because we have been hand soldering and needed flat finish that would solder ok without tarnishing too quickly. I will take a look at the link you pr
Electronics Forum | Thu Jul 30 17:31:41 EDT 2015 | dyoungquist
We are running a Mydata (Micronic) MY15E. The MY100 is the next generation after the MYxxE series. As far as I know, there is no way for the machine itself to check the polarity of ICs to see if 1 or more are in the tube or reel different from all
Electronics Forum | Sun Aug 02 23:12:25 EDT 2015 | galler
For anyone having problems in burning boot loader in an Atmega328, the burnt atmega328 should be the most common tricky problem. some makers users are looking for an alternative to replace it. Now some say that Atmega328P-PU could be a great alternat
Electronics Forum | Mon Aug 03 07:45:49 EDT 2015 | buckcho
Hello, I can give you some information: 1. After uploading of the gerber you have to go to the firs point from where you have to measure and pres "S" if you want the center automatically. After that pres the "zero user" button so you can null there.
Electronics Forum | Thu Aug 06 15:58:20 EDT 2015 | r92024
I'm looking for advice, please, concerning PSB ’s. I’m a complete newbie and not very technically minded, sorry! I manufacture and sell wall clocks that have a swinging pendulum. The pendulum mechanisms are made overseas and designed for the pendulu
Electronics Forum | Mon Aug 10 16:53:26 EDT 2015 | rgduval
If the pendulum is motor driven, it's more likely that a capacitor change will accomplish what you want than a resistor change. You've got a 47uF in there...try a factor of 10, and put a 4.7uF in there and see what happens. If the pendulum period i
Electronics Forum | Wed Aug 12 11:09:42 EDT 2015 | jvalverde
Hello, I have a problem with the solder paste process, I need a solder paste with no Start-up Time because We do not work 24 hours in the manufacturing process, we works only 8 hours a day and at the finish we need to store the paste in the refr
Electronics Forum | Fri Sep 11 12:08:10 EDT 2015 | derrikf
I built one using an old Asymtek Automove. When all was said and done, it cost less than $400, including what was paid for the machine itself. It's a very basic setup, (air over syringe), but for our needs it does everything and more. With air to syr
