Electronics Forum | Tue Sep 15 14:11:59 EDT 2015 | jpal
You should also remove all the pump parts and clean them, checking the bearings and seals. Clean completely the parts that allow the solder to flow back into the pot; ours have a spiral that fills with dross. Treat yourself to new nozzles. Tinning
Electronics Forum | Fri Sep 18 13:11:38 EDT 2015 | dyoungquist
We used to run a TP9-2 but upgraded to the MY series about 5 years ago..... Encoder going bad is a likely possibility, especially on a machine that old. I can't say for sure that is your problem but we did have to replace an encoder on our TP9 (I
Electronics Forum | Sat Sep 26 00:53:54 EDT 2015 | padawanlinuxero
Hi guys, > > Recently got an error message when > initiating hardware on a Mydata TP9-UFP. Message > is: Theta/2: Lower end point not repeatable. > Reinitiating fails at message. Haven't seen this > message before. Any idea what it could be as
Electronics Forum | Mon Oct 12 00:55:02 EDT 2015 | edriansyah
Hi nhel, if you're talking about software back up. it's quite easy. normally when you're system are set by the SAKI tech, they will create a back up of the saki software. this is their standart procedure. mine were located on the My document. he put
Electronics Forum | Thu Sep 24 09:28:13 EDT 2015 | rgduval
No direct experience with this particular issue....but, I do know that measuring capacitance can be tricky. How are you arriving at this conclusion? Are you measuring the caps on the bench before assembly, and then on the boards post assembly? Cap
Electronics Forum | Sat Sep 26 02:09:39 EDT 2015 | aemery
Proc My field service back ground included Electrovert so I know reflow electrical quite well. I've worked on Heller, Conceptronic and Vitronics over the last few years and really there isn't a huge difference if you can read a schematic. I checked
Electronics Forum | Sat Sep 26 14:54:52 EDT 2015 | ercdave1
Hello, just a quick update on this issue. I disabled head 2 on beam 2 which was the second head I worked on, and left only active the head that I had work with first and ran dry cycle with. after disabling the head 2, the machine zeroed with no pr
Electronics Forum | Wed Sep 30 08:29:15 EDT 2015 | johanbergstrom
The difference between TMC Flex and TMD Flex is about the ability to feed component tape with deep pockets for larger components. The TMC have a rather low passage for embossed component tape. While TMC Flex is limited to a maximum tape depth of 7,5
Electronics Forum | Tue Oct 06 14:29:14 EDT 2015 | cadco
Update 6 Oct 15: We have completely re-configured the oven PID boards such that everything is now visible on the oven by the s/w and all is now OK since the "Machine"card is now recognized. We have just one additional procedure to do and that is to
Electronics Forum | Sat Oct 10 11:24:50 EDT 2015 | cusackmusic
I've been running Quads for over 10 years, and I love them. I've had almost every model, from the 100, to our current IVCs, and QSP2. We are getting busier, and I'm thinking about upgrading. I have TONS of feeders, so the simple solution would be t
