Electronics Forum | Tue Sep 20 10:33:19 EDT 2005 | PWH
Lead-free??? You might see these kinds of problems with capillary action in t-hole items more-so than lead.
Electronics Forum | Mon Sep 19 13:15:29 EDT 2005 | russ
It all comes down to cost and reliability. Which order is up to you. You don't want to spend $100 fixing a $1 board.
Electronics Forum | Tue Sep 20 15:37:24 EDT 2005 | intermin
Well, at that value point, I'd go with the hourly ( unburdoned ) high-skill rework/repair rate up to 50%-60% of the board value. If this is part of an integrated system ( in-house assembly ) repair to value ratio could go even higher.
Electronics Forum | Tue Sep 20 15:47:13 EDT 2005 | fastek
Wow! How would it be possible to spend $700-$800 in labor to repair a single board? What are labor burdens these days? $30-$40 per hour at most?
Electronics Forum | Mon Sep 19 07:56:19 EDT 2005 | Pop
How we can improved the Solder voids on QFN Packaging. Actually we adjust the time for solking to long . But is not affected. Pls advise. ThANK YOU
Electronics Forum | Sat Apr 15 14:28:26 EDT 2006 | Dan Mendoza
This may sound like advertasing, but I ran a DOE with five solder paste/flux manufacturers and somehow, the voids went away with the AIM solder.
Electronics Forum | Tue Sep 20 21:49:51 EDT 2005 | davef
2251 - Design Guide for the Packaging of High Speed Electronic Circuits 2252 - Design Guide for RF/Microwave Circuit Boards
Electronics Forum | Sun Sep 25 16:02:59 EDT 2005 | mark
The calibration was ok. When i switch off the back camera and use front one everything is ok. Is it true that when Topaz use back line camera after checking the components the machine rotates the components 180 degree?. Mark \
Electronics Forum | Mon Sep 26 07:56:38 EDT 2005 | pavel_murtishev
Hi! Try to make "R_AXIS_ACCURACY" calibration for all of FNC heads for back camera only. I met such problem on Topaz-X. There was clearly seen offset on 0.8mm pitch components. I simply calibrated all cameras for FNC nozzles and problem disappeared.
Electronics Forum | Tue Sep 27 23:02:55 EDT 2005 | selva Govind
Hi Mark, This problem can be overcome by adjusting the camera brightness - Gain & Offset. I think the offset value is very high. Try reducing it.
.png)
