Electronics Forum | Sat Mar 31 16:59:30 EDT 2018 | menvox
I'm trying to give a second life to a MPM ULTRAPRINT / SPEEDPRINT 200, I'm searcing for a MINJO gear reductor with a ratio 21:1. If you have parts for this printer , or some user/ service files, please let me know.
Electronics Forum | Fri Nov 08 14:45:12 EST 2019 | charliedci
Appreciate the input from everyone. The PCB is .062" thick. As a CM we are at the mercy of our customer at this point although (hopefully) they are receptive to advice on the next build. Titanium strips could be an option, I also thought there might
Electronics Forum | Thu Oct 23 06:58:38 EDT 2003 | chrissieneale
Help! We currently use out SMT for pretty much one-off's. we use BGA's and complex board designs and it looks good to say it's been SMT'd. We are now looking to take on a project (a one off project) that would move our production up from 1 to about 2
Electronics Forum | Fri Nov 08 05:40:54 EST 2019 | leeg
We place these on a few boards and have no issues with reflow or warpage. How thick is your PCB?
Electronics Forum | Fri Nov 08 14:19:59 EST 2019 | dwl
You can try putting titanium stiffeners on the PCB to prevent it from warping. How thick is your stencil? More paste would give you a wider window however too much and you risk bridging. You could try over printing the pad at the heel and toe to get
Electronics Forum | Thu Nov 07 10:07:02 EST 2019 | charliedci
Requesting help from anyone with experience in reflowing Te Connect, PN 1565917-4, 200 pin connecter. Pic attached. Cannot get all 200 pins to wet, main suspect is slight PCB warping during reflow. Have adjusted reflow profile. A 2.75 inch long SMT c
Electronics Forum | Wed May 29 12:55:33 EDT 2024 | mistrthou
Curious if anyone out there has a VIP 200 heat shrink applicator laying about. We have 2 that we still use and are looking to have them rebuilt or re-engineered and we'd like a 3rd to be able to disassemble. I know a lot of you have harness assembly
Electronics Forum | Wed May 29 21:05:33 EDT 2024 | kumarb
Hi. I do not think this is the proper forum for your request. This forum is for electronic circuit board assemblies and related machinery. Do investigate the other parts of this website that may be more appropriate of your request.
Electronics Forum | Fri Jul 18 15:25:19 EDT 2014 | davef
The presence of agitation at an air / solution interface and a foaming agent causes foaming. Most water soluble fluxes contain surficants. Surficants are foaming agents. First, it's likely this foaming is caused by poor control of the temperature of
Electronics Forum | Wed Mar 21 10:37:02 EDT 2012 | torch
we are currently developing a 180 degs downhole tool and are right at the limits of our current solder paste, the tool has mostly surface mount parts and some fine pitch ic's. i was wondering if anyone had any recomendations for a suitable solder pas