Electronics Forum | Thu Nov 10 23:09:45 EST 2005 | davef
Poured flooring suppliers are: * Garland Floor http://www.garlandfloor.com * Sauereisen http://www.sauereisen.com/c_prod/c_esd.htm Vinyl & rubber flooring suppliers are: * VPI http://www.vpiflooring.com/products.php?cat=2⊂=1 * 3M http://products3
Electronics Forum | Fri Jan 05 11:42:15 EST 2001 | John
We are planning out an expansion project. Currently we have vinyl esd tile in our production area. We've found this to be expensive, easy to damage, and a pain to repair. Has anyone had any experience with ESD floor coatings/paints??? Any advice
Electronics Forum | Tue Nov 28 13:21:33 EST 2000 | Graham Naisbitt
Terry The SCC3 product is a vinyl modified silicone. It is less able to perform at low temps as it becomes brittle. It is not easy to repair because it is essentially silicone. It is not a qualified material to the MIL-I-46058 Spec. Are you sure yo
Electronics Forum | Tue Dec 27 09:22:05 EST 2016 | sumote
If this topic is not in line with this forum then please feel free to remove it. Let me start by sating I am a 3M fan. There has not been a 3M product that I have ever thought that I was not happy with the way it preformed, and I have used many 3M
Electronics Forum | Mon Feb 06 17:24:26 EST 2017 | westshoredesign
So I had the same question too when I was setting ours up. My lazy (and cheap) solution was: for each program I have a universal path that is used up to the first dispense instruction and after the last one then I covered the surfaces underneath tha
Electronics Forum | Thu Feb 22 20:53:44 EST 2001 | davef
You're not sposed to pull the mask from the BGA when reworking it!!!! ;-) Well, if you insist. You can be as fancy as you want. Basically, all you need to do form a dam to prevent the solder from flowing from the pad to the via and starving the
Electronics Forum | Mon Dec 01 12:39:06 EST 2008 | tsvetan
this is really nice one ;) paper and cotton have lowest potential to generate static electricity see below, and usually is good practice to wear cotton glowe at least to one of your hands to not leave greasy finger spots on the gold finish of the PC
Electronics Forum | Mon Jan 11 21:34:37 EST 1999 | Dave f
| I know that static concerns are very important in your work. Are static concerns eliminated by the antic-static devices you wear or which are in your environment, or do the hand tools you use, such as picks, tweezers and brushes, need to be anti-st
Electronics Forum | Tue Dec 29 17:42:27 EST 1998 | Dave F
| Can anyone recommend a solder stop that can be applied by our PCB supplier. Our current material form Tamura Kaken is causing problems. | | The material should be capable of withstanding 1 Surface mount IR reflow cycle and 1 wave solder cycle. | W
| 1 |
.png)
