Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Mon Jul 06 22:17:13 EDT 2009 | emanuel
Thanks Jeff, I isolated the problem to the DC servo part. The GD3 signal in the safety circuit chain is the one that generates this L004 Feedback Error - which by the way next to it I get also (Wn) where n is changing form 1 to 3 every time I push r