Electronics Forum | Sat Jan 15 13:13:33 EST 2000 | Mark Wiegold
Steve, Basically in answer to your question, there is no real set number for defects. Defect rates will vary between products and companies. If my company was running the same product as yourself then there is no reason to suggest that the defect ra
Electronics Forum | Mon Jan 17 12:16:02 EST 2000 | Brian W.
My old company (CM) ran SMT to 50ppm including some very complex boards. We established the normalizer number by: #components + #solder joints. As was stated earlier, the ppm for any given product is the result of many factors. You may get differen
Electronics Forum | Sat Jan 15 16:59:47 EST 2000 | Steve Thomas
Thanks, Mark. Actually we already have an established mark. We use 500ppm (99.95%) as our acceptable level. Problem is, someone (another manufacturer) told someone else (our pres.) that THEY build to 50ppm. Soooooo, someone else told my boss that
Electronics Forum | Tue Jun 23 11:08:42 EDT 1998 | Russ Miculich
| Any ideas on what to buy? Only need to build surface mount protos, ability to rework. Is a rework station okay? | Will subcontract production after design is proven. Best bet is to get an Elite or OK Industries manual printer if you are not doing
Electronics Forum | Mon May 18 10:54:46 EDT 1998 | Jerry
If it's really low volume I would only invest in a stencil printer and convection reflow oven to start with. If you want to go really low budget get a manual unit such at one from Transition Automation. Make up some really good shop aids and have s
Electronics Forum | Tue Jun 15 12:03:27 EDT 1999 | Dave F
| Has anyone had issues where bottomside double reflowed smt has fallen off in the wave when using voc-free flux? I have verified the hotter profile was not the issue by using an alcohol based flux with no problems.This voc-free flux is also not caus
Electronics Forum | Wed May 27 13:42:08 EDT 1998 | Chrys
| R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommen
Electronics Forum | Wed May 27 14:35:52 EDT 1998 | Justin Medernach
| | R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recomm
Electronics Forum | Tue Sep 11 19:54:52 EDT 2001 | gsparka
HELLO. SMTNETERS there is no company in high mix low volume system in our contry so . what is the best way to calculate the capa. of smt line in high mix low volume. & what is the general way to get the defect rate to evaluate the smt line(or sm
Electronics Forum | Tue Sep 11 20:42:16 EDT 2001 | davef
Some folk at Cookson in Rhode Island [US] developed software to answer questions like you appear to be asking. Cookson licensed it to some meatheads in New Jersey that made a total mess of the whole thing. Then, Phil Zarro in New Hampshire got it
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694