Electronics Forum | Tue Nov 17 21:03:46 EST 2015 | wesleyintelli
Our Speedline MPM UP100 has stopped displaying anything on its monitor where the fiducial positions are usually taught with the camera images. The vga cable is working. Are there any commonly occurring issues with the vga vision board? The rest of th
Electronics Forum | Sun Nov 22 17:52:49 EST 2015 | wesleyintelli
Hi Deni, Thanks for your interest in my problem. It turned out that the power supply to the VGA vision board (the system in the black box)was faulty. I replaced it with a universal PC power supply and all is well.
Electronics Forum | Thu Apr 29 13:27:36 EDT 2004 | Kirk
Is it possible to put PCB to the screen printer with vision and on the board put sheet of paper then make print on the paper and it is the reference then i teach vision for example fine pitch aperture then remove paper and align PCB? We have semi-a
Electronics Forum | Thu Apr 29 10:49:05 EDT 2004 | pjc
Yes, using an illuminated magnifing glass helps. How well your board fixuring is on the table will effect print alignment on other boards loaded. 0.5mm & 0.4mm will require very good fixuring, like you can get with tooling pins if the board has non-p
Electronics Forum | Mon Apr 26 14:42:47 EDT 2004 | Kirk
so the first PCB if i want to aligned with stencil is manual the same for screen printer without vision and vision starts work for next boards? or i am wrong? but if i make mistake during aligment process for the first PCB i will repeat it for next P
Electronics Forum | Mon Apr 26 15:04:14 EDT 2004 | pjc
You are correct in understanding that the vision system comes into play for subsequent boards- to align them. Yes- if you missalign the first board and set the cameras to that board, all subsequet boards will not be aligned. Mylar is a thin polyester
Electronics Forum | Fri Mar 26 23:07:07 EDT 2010 | dekhead
Just a guess: Are you printing your fiducials on the fiducial side of the board? Fidicial Side is for Vision Calibration, Bare Copper Side is for Offset Calibration (Step 5 of procedure says "copper side uppermost"). After printing 25 fiducials o
Electronics Forum | Thu Apr 29 16:58:00 EDT 2004 | pjc
You should be able to get a one-print Mylar frame for the SMTech 90 machine from SigmaPrint, http://www.sigmaprint.co.uk Yes, with vision you store images of two features such as solder lands or fidicial marks from opposite corners of the board. With
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Fri Mar 26 21:48:56 EDT 2010 | dman97
Can someone explain to me what I'm supposed to do after I have done the vision offset calibration procedure? The manual tells me to put solder paste down on all 25 holes of the stencil. After this the board drops down and the machine scans each fidu
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
winsouce.jpg)