Electronics Forum | Mon Feb 18 08:11:27 EST 2019 | tomazicrok3
hello i have samsung cp40cv and this errors comes up can someone help me. vision communication error(1000)(1000), no sequence-finished from handler(%1), no command response from handler (0x2002).
Electronics Forum | Tue Feb 19 02:03:51 EST 2019 | bukas
try first to replace SYS folder, or one by one of its files. if that doesnt work you are looking at complete disk backup. and check disk for bad sectors ofc
Electronics Forum | Mon Feb 18 09:49:43 EST 2019 | bobpan
This is going from my memory from a long time ago...but in the scp.ini file....there could be digital light control and/or a matrix tray handler setting. I would turn them off if they are on. I believe this has something to do with a system setting.
Electronics Forum | Fri Dec 31 12:26:29 EST 2010 | kvael
Has any one had this problem? Dynatech says it is the I/O Dpram board, sold me one that dosen't work. Bought a second Dpram from SMTBOX, still have the same original problem. During Dpram initialization error comes up "no command response from handl
Electronics Forum | Sun Dec 28 19:13:03 EST 2014 | kahrpr
Its been a long time but a CP40 will not run under XP its win 95 or win98 only and I believe it can only use the original style mother board.
Electronics Forum | Fri Dec 17 09:04:17 EST 2010 | wolverine
We have an older model CP40-LV that will start out the day with blurry and double vision, then after about twenty minutes of just idling, the vision slowly improved until the machine could find the board fiducials and do a passable placement job. Th
Electronics Forum | Tue Jan 24 08:01:32 EST 2012 | wolverine
When using the rectangular plate given with the machine that is used with calibrating the movable camera, does the longer side of the plate get fed into the machine ( rails set to 80mm ) or the shorter side ( rails set to 74mm ) Thanks Dave
Electronics Forum | Sun Jan 29 12:55:38 EST 2012 | tech_fun
i don't thing that it is a rule. the only ideea is to mov the camera exactly above the hole in the middle.
Electronics Forum | Thu Apr 29 10:49:05 EDT 2004 | pjc
Yes, using an illuminated magnifing glass helps. How well your board fixuring is on the table will effect print alignment on other boards loaded. 0.5mm & 0.4mm will require very good fixuring, like you can get with tooling pins if the board has non-p
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
