Electronics Forum | Sat Mar 24 07:07:52 EDT 2007 | stefi
Hi, Thanks for the reply, The fiducial which posed problems is a 1 mm diameter gold plated circle fiducial. The problem with this is that the vision system sees it darker than the surrounding area. The surrounding area is all copper covered with th
Electronics Forum | Mon Jan 03 14:38:42 EST 2011 | leemeyer
I had this problem awhile back and it turned out to be a problem with the computer Bios settings. The battery had gone dead and the settings were set back to the default state. Luckily I have 2 of these machines and was able to reset the Bios configu
Electronics Forum | Fri Nov 07 08:43:51 EST 2008 | markgray
I am having issues with the SOT23 vision code. All of the numbers match what is in the book but when the camera looks at the part it centers on the bottom edge of the lead not the center of the lead. I beleive that there is a problem with the algorit
Electronics Forum | Fri Oct 09 06:53:10 EDT 2009 | taus
Hello, I've recently started to work with MPM AP25, I began doing maintenance to get to know the machine. But now I'm having some problems in the teaching process. You can see the problem in the photo. http://img59.imageshack.us/i/image194p.jpg/
Electronics Forum | Mon Dec 12 14:05:45 EST 2005 | derengmao
I tried to use the Fixed Camera to inspect TSOP, however, I got either "UPPER SIDE END PIN ERROR", or "Missing Group:1". I have never had a parts getting recognized. I adjusted all parameter possible: Light, size, width, length. By using Dispaly Par
Electronics Forum | Wed Jun 22 10:12:31 EDT 2005 | slthomas
I don't know how your printer could match the board's alignment to the stencil if they aren't. If you don't have fids on both board and stencil that match you'd have to use pads, but then you've got apertures thrown in to the mix. If that's the sit
Electronics Forum | Fri Apr 02 17:09:30 EST 2004 | davem
Jaimebc is right. You must match the orientation in the Component ID (Default Rotation in Feeder) to the rotation in the Feeder List and the actual orientation in the feeder itself for the vision to properly recognize the component. This still doesn
Electronics Forum | Mon May 13 13:45:33 EDT 2019 | whitelancer64
I am having the same problem with the MPM Accela solder paste printer machine. If the fiducials are adjusted for PCB alignment, the location of the paste is then wrong, and vision inspection fails. This is a problem for both pad preview inspection
Electronics Forum | Wed Nov 12 06:23:09 EST 2008 | griffin
One thing to consider regarding the capacitor, The leads are not 100% straight beneath the plastic bottom part. And if you align with regards to the two leads, the leads will be aligned to the pads of your board, but the body of the capacitor is look
Electronics Forum | Tue Jun 01 18:06:36 EDT 2004 | Rob
I used an Ultraprint 2000 so if that's what you use then maybe I might be able to help. First, I'm assuming that you've already passed the Teach New Board section. This is board dimension, X and Y boardstop, stencil/squeegee heights and strokes. If
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
winsouce.jpg)