Electronics Forum | Sat May 21 07:23:38 EDT 2005 | ajaydoshi
We do face problem in CP643E, - Vision system alarm & later machine require to turn off. This problem ocurrs once in a week ( average ) Checked up Fuji along with trace data but could not able to get any solotion. Any recommondation. ajay doshi
Electronics Forum | Tue Oct 16 01:29:11 EDT 2012 | dman97
I have a very odd problem with my Fuji IP3 and was wondering if anyone can help. Any part that gets picked from the MTU will fail vision recognition. After turning on the vision trace data, I can see that the IP3 is looking for the part to be rotat
Electronics Forum | Tue Dec 06 19:44:10 EST 2011 | comando
Hello every one! I need help with a misaligned theta at plcc44, the machine is a IP3 smd3, firmware 2.99, vision card 4400 and both camera type YD2048N on label but in Proper data is set 2 (I don't know if this is right) we use Fuji flexa, Back Lig
Electronics Forum | Wed May 27 18:19:58 EDT 2009 | dcell_1t
yesterday I tried with vision type 20, just defined the two pair of leads and error 1CA14003 came up, on flexa error help says the following: Cause: The Vision_type in part data is expressed using hexadecimal notation (??). If ?? equals 0A, 0B, 0C,
Electronics Forum | Thu Jun 23 03:43:45 EDT 2005 | ajaydoshi
Hi Jerry, > > Thanks for the info. Is vision > number required for the IP3? From the manual it > appears not (needed for IP1 & 2), however vision > type is required. > > Thanks, Dave We are using IP3 & placing BGA. BGA part data only for outer
Electronics Forum | Tue Oct 21 04:45:13 EDT 2008 | stanyserrao
Head 1 is not placing the parts in production. Same component is placed by head 2. Head 1 camera is camera 12 type and head 2 camera is type 8. Machine re-set done resent proper data and interchanged cameara still same problem was foundd in head 1.
Electronics Forum | Mon Nov 10 23:20:55 EST 2008 | stanyserrao
Light Units are replaced with new if the problem > of lights then it will not vision process the > nozzle center measrement and resolution Jigs > too.. > > Jig is meauring in trace mode and > identifiying all leads which are fine > fitch. > >
Electronics Forum | Wed May 27 16:39:33 EDT 2009 | rmitchell
Hi, I think vision 20 will work as well. If not we have used 100 or 105. Have you tried placing the part with the machine trace on? If so is it finding all the leads? any error codes? If you are defining the leads in the EL lead data I would not d
Electronics Forum | Thu Oct 23 00:43:30 EDT 2008 | stanyserrao
Light Units are replaced with new if the problem of lights then it will not vision process the nozzle center measrement and resolution Jigs too.. Jig is meauring in trace mode and identifiying all leads which are fine fitch. But a 1206 resistor is
Electronics Forum | Sat Jul 29 12:52:38 EDT 2000 | Larry Johnson
Okay, here is the deal. When result is turned on in trace, I have parts that place fine, square as can be. When I turn result off, they skew. This isn't on all parts, I have tried different vision types, with no improvement. Currently using #100.
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723