Electronics Forum | Fri Jun 06 15:12:05 EDT 2008 | tomwho
Can anyone give me a contact for someone who sells used vitronic reflow oven parts. I am look for heater panels or heater wire for a vitronics smr-820 reflow oven,or some place that can replace the heater line in them. Thank you
Electronics Forum | Wed Jan 18 10:35:17 EST 2006 | pms
Thanks folks !! I'll experiment with the bottom side heaters. Unfortunatly I don't think our Vitronics-Soltec oven has the option for adjusting the heater fan speeds. And I'll check the conveyor chains. This is our first project using 0402 parts, wh
Electronics Forum | Thu Oct 28 20:13:39 EDT 2004 | grayman
The same with Russ, I would look at Vitronics and BTU. based on my experience they give best results especially on the profile. Maintenace is also superb! BTU has modular blower, heater T/C assy. Vitronics is "XPM - NO PM System" Now, BTU offers lif
Electronics Forum | Thu Mar 14 13:48:18 EDT 2013 | cyber_wolf
The entire oven is clean there are no blockages and the heater plates are brand new. I have worked with Vitronics technical support and gone through this thing with a fine tooth comb. I have even gone as far as to compare the exhaust and intake cap c
Electronics Forum | Mon Oct 17 14:00:14 EDT 2005 | ricardof
for sure it's an excelent topic, in Mexico we've used almost any brand in the market (Research, Heller, Electrovert, Rhem, Vitronics, Conceptronics, BTU) and after all those names, we could see that Vitronics is a good opton, good service, not too mu
Electronics Forum | Wed Mar 13 06:37:24 EDT 2013 | jlawson
Not knowing XPM ovens , have zones are usually top heat and bottom, you replaced one heater panel-platten thus have a another above or below, maybe one above or below also is faulty causing heat spot on one side of oven ?
Electronics Forum | Mon Mar 11 09:46:04 EDT 2013 | cyber_wolf
The surveyor is a a plate that I use to "survey" or verify the oven on a weekly basis. The data logger or profiler is the actual unit that follows the board through the oven to take readings. I don't think the zone thermo couple that measures temp a
Electronics Forum | Mon Mar 11 09:38:05 EDT 2013 | markhoch
Maybe I misinterpreted, because different people have different names for different devices, (i.e... I believe that the device that you refer to as your "surveyor", I refer to as a "profiler"), but did you already determine that your oven thermocoupl
Electronics Forum | Fri Jan 12 11:46:26 EST 2018 | emeto
I don't know this exact oven, but usually it goes like that: First is a three phase power, then it is a contactor that is switching the power for the heaters and fans. than there are transformers for lower voltages. then there might be UPS system in
Electronics Forum | Sat Sep 26 02:09:39 EDT 2015 | aemery
Proc My field service back ground included Electrovert so I know reflow electrical quite well. I've worked on Heller, Conceptronic and Vitronics over the last few years and really there isn't a huge difference if you can read a schematic. I checked