Electronics Forum | Wed Mar 21 07:44:19 EDT 2012 | cuervo
Hello ! I have a vitronics 500s ( five zones), and the solder paste is ALPHA OM-338-PT lead free. have anyone a profile to start and test, i need some reference temperatures.and conveyor speed thanks !!!
Electronics Forum | Thu May 05 18:14:11 EDT 2005 | rtorres
Hello we are having a problem with an Unitherm 500 reflow oven from Vitronics. the conveyor is not responding to the system, the speed is out of control, it seems to be alerted. Does any one know what is going on. your help is greatly appreciated. Re
Electronics Forum | Wed Nov 11 23:01:10 EST 1998 | Jason
| The only announcement that I have seen affects the line of printers (SMTech was purchased by Quad several years ago). | | is it true that Quad Systems has been acquired by Speedline? Can anyone confirm or deny this? | | | | SMTech was purchased
Electronics Forum | Mon Dec 12 22:14:42 EST 2005 | davef
�a va Frank? Well, popularity depends on the beholder. Never heard of your "Specnor" machine. US and Eurolanders take different approaches to conveying boards. * US: Finger conveyors * Eurolanders: Pallet conveyors Suppliers of wave solder machin
Electronics Forum | Sat May 07 04:28:51 EDT 2005 | grayman
try checking the speed/conveyor driver,encoder,comunication I/O Board system and lastly the program. If the driver is at fault replaced it do not repair it. If software try to load it again but make back up.
Electronics Forum | Mon May 09 08:20:52 EDT 2005 | stepheniii
I am not familiar with these ovens, but most I have seen have an optical emmitter reciever and a some kind of sprocket with holes to measure speed. If there is dust build up on the emmitter or reciever, this can cause the speed to increase because th
Electronics Forum | Wed Jun 06 18:20:09 EDT 2007 | rm14
I am experiencing issues with the chipwave of this machine. The solder is not smooth and looks very rippled. I have cleaned the system but with the same results. This condition is leaving me with no-solders. Anyone seen this. Also should the nitroge
Electronics Forum | Thu Nov 14 08:25:16 EST 2013 | aj
Hi all, I am looking for a replacement encoder for the conveyor. Model #: 2112001000 Danaher Controls If anyone can assist on the 2nd user market? aj...
Electronics Forum | Wed Feb 14 15:49:30 EST 2018 | cbart
Did you check each leg alone to ensure you have proper incoming voltage to the machine on each individual line? any other 3 phase issues in the building? do you have a UPS for pc and conveyor purposes? is that failing?
Electronics Forum | Wed Jan 18 10:35:17 EST 2006 | pms
Thanks folks !! I'll experiment with the bottom side heaters. Unfortunatly I don't think our Vitronics-Soltec oven has the option for adjusting the heater fan speeds. And I'll check the conveyor chains. This is our first project using 0402 parts, wh
