Electronics Forum | Tue Apr 16 15:51:34 EDT 2019 | kgarlapa
we don't have a jumper shunt in this conveyor. This conveyor belt running forward direction since 5 years but all of sudden change to reverse direction. Is this any software issue? Note: Both side sensors are working fine
Electronics Forum | Thu Oct 14 08:14:36 EDT 2010 | rway
We use both Panasonic and JOT. JOTs are a good conveyor. The Panasonics will probably cost you less. Check the used equipment market. That's where we got all of ours and I haven't had any issues with any of them except the normal where and tear o
Electronics Forum | Thu Mar 02 07:31:02 EST 2017 | coryhayes89
I ended up finding that the laser switch on the exit side was actually getting tripped by the conveyor itself. Had to move the beam to be between the belts and it started working properly again. It seems like the 'fixed' conveyor side actually cam
Electronics Forum | Wed Mar 01 07:48:33 EST 2017 | coryhayes89
I have an older Flexlink F1700 that I am having issues with and am hoping someone might have a fix for it. The issue is that the machine will initialize when you turn it on, meaning the belts will spin. However, it never returns to its 'home' posit
Electronics Forum | Wed Jul 04 14:22:51 EDT 2001 | davef
I just rooted through an analysis that we did five or six years ago [so current it aint] and finally found the goods. We talked to Vitronic, Heller, Electrovert, IR, and Conceptronic. Only Electrovert had a 2.75" throat [rail to top of board cleara
Electronics Forum | Wed Feb 14 15:49:30 EST 2018 | cbart
Did you check each leg alone to ensure you have proper incoming voltage to the machine on each individual line? any other 3 phase issues in the building? do you have a UPS for pc and conveyor purposes? is that failing?
Electronics Forum | Wed Jun 06 18:20:09 EDT 2007 | rm14
I am experiencing issues with the chipwave of this machine. The solder is not smooth and looks very rippled. I have cleaned the system but with the same results. This condition is leaving me with no-solders. Anyone seen this. Also should the nitroge
Electronics Forum | Fri Apr 08 17:23:34 EDT 2005 | KEN
Warpage factors can cause: 1. Boards can not transfer down conveyor belts or wedge at transitions. 2. May not enter into machinery due to interferences (like board clamps) 3. May fall off conveyor chain in furnace. Especially true of thin (PCMCI
Electronics Forum | Mon May 06 03:12:30 EDT 2019 | oxygensmd
Is the belt tension right? Are the axes tacho - acceleration right? On the F5 with output conveyor problem seems to be K2 relay problem. If you are open-closed the door (stop and restart the controlling) helps, the K2 is the problem.
Electronics Forum | Mon Jan 20 09:55:09 EST 2003 | Claude_Couture
The carrier tape and cover tape of static sensitive components are either conductive or dissipative. as for the P&P machine, as long as they are made of metal and grounded, static buildup is not an issue. All PCB conveyors I've seen have static condu
