Electronics Forum | Fri Jan 12 09:22:51 EST 2018 | dskling
Hello We have a Vitronics XPM820 that has us stumped. We have replaced both power supplies (G1 and G2) and we still cannot clear this alarm. The A1 board has all 4 leds light for proper voltages. We have verified that we are getting the correct vo
Electronics Forum | Fri Feb 16 04:15:57 EST 2018 | sachinverma
hi , please check the main S/w. of the Reflow machine.
Electronics Forum | Wed Feb 14 15:49:30 EST 2018 | cbart
Did you check each leg alone to ensure you have proper incoming voltage to the machine on each individual line? any other 3 phase issues in the building? do you have a UPS for pc and conveyor purposes? is that failing?
Electronics Forum | Fri Jan 12 11:46:26 EST 2018 | emeto
I don't know this exact oven, but usually it goes like that: First is a three phase power, then it is a contactor that is switching the power for the heaters and fans. than there are transformers for lower voltages. then there might be UPS system in
Electronics Forum | Mon Mar 11 07:58:59 EDT 2013 | cyber_wolf
So I have this issue with my 1240. During my weekly oven surveyor check I get a software alarm that says I am out of tolerance. Probe #3 which is closest to the hinge side of the oven is approx. 10 degrees hotter in zone 12 than the other 2 probes o
Electronics Forum | Tue Aug 24 22:32:18 EDT 2004 | pdeuel
We have a Soltec Deltawave with single nozzle spray fluxer, chipwave, and waveform. It preforms well. I am not fimilar with Electrovert models so I can only give you some of the pitch I got when I went back East for training. Features I like about th
Electronics Forum | Sun Nov 27 11:32:30 EST 2005 | cyber_wolf
They may tell you it will solder lead free,(and it may) but trust me...you are going to have nothing but headaches. If you start flooring the heaters you are going to put it into a "melt down" after a while. I know you don't want to hear it, but tak
| 1 |
