Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Thu Oct 22 12:30:33 EDT 2020 | emeto
So is the initial motor at fault failing now or the one from zone 3?
Electronics Forum | Wed Feb 06 02:14:43 EST 2008 | mun4o
Hi, we use Vitronics Delta 6622 solder wave.I try to adjust high of backplate, but I don't know whether the adjustment is correctly.Now, when the frame enter in the main wave, solder flow in the same direction as PCB.But when the frame go above main
Electronics Forum | Tue Sep 17 13:58:56 EDT 2013 | smtventasmex
i have a vitronics Delta 6622CC with a software fail, i turn it on and when i open the software on the CPU, it enter but show me a message of wrong vertion, and then i choose ok and software close it self, let me know if some one of you have this fai
Electronics Forum | Fri Sep 14 10:53:25 EDT 2012 | mili
In Setup menu there is a last option Debug. Debug choosing a window with Rack0, Rack1, Rack2, Rack3, log RS485 opens. Choosing rack0 a window with parameters S3 boxes 1 to 12 Input and certain boxes are checked, S4 Output from 1-8, from 1-8 S5 Outpu
Electronics Forum | Fri Sep 14 08:53:43 EDT 2012 | mbnetto
Hi, Recently we acquired a Delta 3 and I noticed everytime we change any value regarding to the tracking system, as chip or main wave - offtime/ontime- with boards loaded on it, the tracking system doesnt work well. sometimes it turns off the wave o
Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg
Electronics Forum | Fri Jun 15 12:07:13 EDT 2018 | fern
My company is hooking up a delta max wave solder machine but we can seem to get the estop error to go away any one have a any experience with this issue.
Electronics Forum | Mon Apr 09 11:31:36 EDT 2018 | emeto
I would still focus on the sensors first. Experiment and see if they are really registering correctly. Still might be a sensor malfunction, timing issue(enough time to register)or some actual debree on it that prevents it from changing state properly
Electronics Forum | Mon Apr 09 13:50:38 EDT 2018 | justconmac
Thank you, yes I am definitely going to go back through and clean them thoroughly and monitor them, especially at rack location.