Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Wed Feb 06 02:14:43 EST 2008 | mun4o
Hi, we use Vitronics Delta 6622 solder wave.I try to adjust high of backplate, but I don't know whether the adjustment is correctly.Now, when the frame enter in the main wave, solder flow in the same direction as PCB.But when the frame go above main
Electronics Forum | Tue Sep 17 13:58:56 EDT 2013 | smtventasmex
i have a vitronics Delta 6622CC with a software fail, i turn it on and when i open the software on the CPU, it enter but show me a message of wrong vertion, and then i choose ok and software close it self, let me know if some one of you have this fai
Electronics Forum | Fri Jun 15 12:07:13 EDT 2018 | fern
My company is hooking up a delta max wave solder machine but we can seem to get the estop error to go away any one have a any experience with this issue.
Electronics Forum | Mon Dec 17 02:08:21 EST 2007 | mun4o
Hi, I have a lot of solder bridge in our wave soldering process.We use SACX0307 and Surf 11 flux.the SW mashine is Vitronics delta 6622.Itry to change flux and termoprofile but results is not god.Can you halp me - recommend me some flux or other adv
Electronics Forum | Thu May 17 09:00:51 EDT 2007 | bsteffen
Since your budget is between 25 and 30K I would say you have plenty of options. Electrovert and Vitronics are both good solid machines. Seho is another option. Seho is extremely user frendly and maintenance freindly and easy to profile however, it is
Electronics Forum | Fri Jan 01 09:00:21 EST 1999 | John Smith
Give me your opinions and experiences of SelectX, selective debridging system in the Vitronics Soltec wave soldering machines.
Electronics Forum | Tue Aug 22 12:04:11 EDT 2006 | rlackey
No, not by us mere mortals but where there WML there's hope. I'm not convinced the package would like around 260C either. Disclaimer: Please note I am just a simple engineer and was not privileged enough to attend Soltec University, instead having
Electronics Forum | Tue Feb 14 03:58:17 EST 2006 | Rob
Yes, it's fine - as Pete says you have to replace certain parts & either get the pot recoated or a new one. We ran a "Lead free" 6622C from Vitronics Soltec on Tin Lead, then it was cleaned up, recoated and loaded with a no-lead alloy with no proble
Electronics Forum | Thu Jul 31 02:40:20 EDT 2008 | JH pbf
We use Axarel 2200 as recomended by Vitronics Soltec, which is the same as we use on our MPM printes for under stencil cleaning. It is non-ozone depleating and has a high flash point. For insurance purposes we banned IPA from the shop floor some
