Electronics Forum | Sun Sep 02 09:06:42 EDT 2018 | davef
Cold resistance between the tip of the tool and the ground reference, tip current leakage, and tip voltage. per ANSI ESD STM 13.1 J-STD-001 Rev G, Appendix “A” Guidelines for Soldering Tools and Equipment: A-2 BENCHTOP AND HAND SOLDERING SYSTEMS Se
Electronics Forum | Fri Sep 02 04:18:48 EDT 2016 | bukas
i have tested voltages on Processor board X12. all voltages are ok and stabil but +VPP (PT8 - TP9), it reads 0 volts
Electronics Forum | Wed Feb 22 12:40:41 EST 2006 | russ
Here are some of the things we had to do when we had to validate process. Incoming voltage Air pressure squeegee speed placement accuracy oven stability
Electronics Forum | Mon Jun 18 11:15:53 EDT 2001 | Gil Zweig
The cost of an x-ray inspection system will be determined by the following inter-related paramers: 1. The focal spot size of the x-ray source. 2. The maximum tube voltage. 3. The physical size and shielding requirements of the systems. 4. The design
Electronics Forum | Fri Apr 30 18:28:57 EDT 1999 | Mike Doherty, EMCO High Voltage Corp
We are searching for an integrated passive component (or device) consisting of a resistor in series with a capacitor in an 0805 package. Cap value is .01uF, resistor value up to 1 meg. Any suggested sources appreciated. Miked@emcohighvoltage.co
Electronics Forum | Thu May 18 11:55:15 EDT 2006 | RLM
Is a Juki feeder a stand alone unit or does it need to communicate with the assembler ? I can operate a Quad feeder just by hooking it up to a proper voltage source. No need to communicate with a computer. If the Juki's will operate this way maybe I
Electronics Forum | Mon Jul 04 05:13:43 EDT 2016 | lukvel
I have some boards which are charged with electrostatic and which are not connected to any voltage source. I am removing all the electrostatic charge by grounding them using a very similar technology to that of ESD mats. Is there any standard which
Electronics Forum | Thu Oct 25 01:13:55 EDT 2018 | mk15
thank you for your advice, the problem was in the elmo source 350V, there was a problem of dropping voltage when the engine accelerated.
Electronics Forum | Wed Oct 06 08:49:36 EDT 1999 | Dave F
| | | | Can someone suggest what material I have to use to protect components by electrical discharge on ptfe based boards? | | | | It should have high resistivity, thermal stability (-40 +70 'C),perfect adherence on ptfe... | | | | Many tahnks | |
Electronics Forum | Fri Jan 15 15:17:21 EST 1999 | Earl Moon
| | Hello, | | | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | | | So far, the tests I can think of performing, and tha
Distributor of hot-sales and hard-to-find electronic and electromechanical components and supplies. Online catalogue, data sheets and purchasing. win-source.net
100 N HOWARD ST STE R
SPOKANE, WA USA
Phone: 086-755-83957766