Electronics Forum | Sun Feb 06 12:59:33 EST 2005 | GC
Please try to use 6-8 mils ..you are overloading pads surface ..Please verify paste volume vs surface..Have fun
Electronics Forum | Thu Oct 13 21:43:47 EDT 2022 | sarason
If you are running resonable volumes of the board, redesign it with equal copper on both sides. One way of achieving this is to just run copper flood planes on both sides of the board, this is a fairly common technique in RF and noise sensitive analo
Electronics Forum | Thu Dec 09 07:21:10 EST 2010 | scottp
You won't have 2 mil height because the solder doesn't remain brick shaped. It's a dome. In the past I tried doing some calculations using the formula for the volume of a spherical section and also tried using a simulation program that accounts for
Electronics Forum | Wed Jan 17 20:48:14 EST 2001 | davef
We find that the raw BGA's pad sheared surface has the SnPb solder at various Z heights whereas the assembled BGAs pad leave a smooth layer of SnPb along the pad. Like to understand the cause for the difference. Who could guess? Solder joint streng
Electronics Forum | Fri Jul 30 17:13:30 EDT 1999 | Dave F
| | | Looking for solder paste specification limits which have reliability data to support them. Currently, we are looking to define the min/max volume necessary to ensure a good joint on CBGA, PBGA, and Micro-BGA's. Any information will be greatly
Electronics Forum | Tue Apr 25 16:35:24 EDT 2006 | russ
Looking at who is distributing them should tell you something!!!!
Electronics Forum | Tue Apr 25 17:01:23 EDT 2006 | slthomas
tsk, tsk, Russ. You're not usually so judgemental. ;)
Electronics Forum | Tue Apr 25 22:50:05 EDT 2006 | davef
A toaster oven is an improvement over hand soldering.
Electronics Forum | Wed Apr 26 09:41:28 EDT 2006 | russ
My bad
Electronics Forum | Mon May 22 13:52:30 EDT 2006 | VRC
Is this oven still available and what is the condition.
