Electronics Forum | Wed Mar 24 09:22:16 EST 1999 | justin medernach
| We might be doing a job with some plcc, soic on one side and the other side will have two BGA's. Does any one have any ideas on what knid of problems that might occur if we reflowed both sides? Like heat temp, surface tension, etc. Thanks for any h
Electronics Forum | Thu Jun 29 09:29:46 EDT 2000 | JAX
sree, You might want to check the archives. If not, I found this just a few questions below yours!! [Back to thread listing at top] Posted by Igmar on June 22, 2000 at 10:27:26 AM EST Can someone please help with the aperture size on a Micro BGA st
Electronics Forum | Fri Jul 30 17:13:30 EDT 1999 | Dave F
| | | Looking for solder paste specification limits which have reliability data to support them. Currently, we are looking to define the min/max volume necessary to ensure a good joint on CBGA, PBGA, and Micro-BGA's. Any information will be greatly
Electronics Forum | Tue Jun 08 17:52:53 EDT 1999 | Chrys Shea
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
| 1 |
winsouce.jpg)
