Electronics Forum | Fri Aug 24 09:29:08 EDT 2007 | jgrootkoerkamp
Solder balls with wave soldering can have different causes. The two most important are the solderresist and the flux. I have similar problems, after changes the flux type 90% off all solderballs are gone. KR, Joris Groot koerkamp
Electronics Forum | Wed Aug 27 13:08:30 EDT 2008 | vladig
Td - is the degradation temperature for a laminate (board), while Tg - is glass transition one. There is one more (even more important) - delta Tg. They characterize the quality of the laminate material. Regards, Vlad www.sentec.ca
Electronics Forum | Fri Mar 19 10:27:42 EDT 2010 | karlo
No clean pastes leave more flux residues. These can result in void formation and inhibtion of underfill curing. Selection of an underfill that is compatible with the flux residue is important. One company that has written about the effect of flux
Electronics Forum | Tue Feb 14 22:20:10 EST 2017 | swestheimer
Hi Dave, Thank you for your inputs as they were good suggestions. I however let out one important detail and that this is IMS material and not glass reinforced so I think that there is more bending going on during processing than warping and twistin
Electronics Forum | Sun Mar 01 15:52:13 EST 1998 | Earl Moon
| From several months I am investigation about the VOIDS PERSENCE and his important as reliability. | One question now is : | It is possible that on the BGA components the voids are already present into the balls, before the mounting on the pcb ? | I
Electronics Forum | Fri Mar 27 12:46:23 EDT 2020 | unisoft
Unisoft has been import gerber only for years to setup assembly, aoi machines, etc. *** Help for Importing GERBER only files for used in programming Assembly, AOI, Test, Selective Soldering machines (X/Y Center, Rot, Part#). Also allows you to cre
Electronics Forum | Tue Mar 04 15:46:00 EST 2003 | EW
I'm not sure to what degree you are manually crunching this data.....If you can set up the data manually, or parse the data from a recording function, to allow it to import into a database with a formula for Cpk, and everything else you could ever in
Electronics Forum | Fri Mar 03 14:40:22 EST 2006 | amol_kane
i think a more important issue here would be the reduction ratio. as LF solders have a higher surface tension, they do not flow as well as their leaded counterparts. therefore the stencil design may have to be changed (hence a new stencil) if the red
Electronics Forum | Tue Jul 11 10:13:22 EDT 2006 | SWAG
Over time, you might see problems with delam., blistering and warpage if using FR4 carriers. Depending on volumes, you might consider using durostone or some robust material like that for the production runs. Keep in mind that switching materials w
Electronics Forum | Tue Mar 04 17:47:19 EST 2003 | msivigny
Hello EW, thanks for your input, the data collection for measurements such as these can get confusing because you're calculating deviations from set point location to actual placement location and then analyzing the full result. Then there are many o
Buy and selling used smt，semi， Robot ,CNC and all used machines
Equipment Dealer / Broker / Auctions
DONGGUAN HUMEN
Dongguan, 30 China
Phone: 13560819457
.png)
