Electronics Forum | Wed Dec 16 11:18:24 EST 1998 | Jason Gregory
I did see the Amistar at NEPCON Texas and it appears to be a fine machine. The multi-heads and vision-on-the-fly is nice. Feeder capacity seems to be a concern, though. Ibelieve it holds 120 8mm feeders and if you purchase a tray sequencer, it takes
Electronics Forum | Wed Oct 28 19:45:33 EST 1998 | Ron Gilman
I will try to answer some of your questions. My name is Ron Gilman and I am President of Chipscale Robotics here in Fremont California. We manufacture Die Pick & Place equipment and would be happy to send you brochures. Please email me with your a
Electronics Forum | Wed Sep 13 12:10:13 EDT 2006 | SWAG
I don't know about industry standards - I suppose it depends on your equipment, really. We are low-volume, high-mix with many, many part numbers. Here's what we do and we have pretty good luck with it: Over-issue parts to kits; 10 over on 1206's,
Electronics Forum | Tue Apr 02 12:53:47 EDT 2013 | microaide
I have entered my machine configuration as much as I can figure it out. I will have two machines. One with tape feeders, and the other with vibratory (tube) feeders and a waffle feeder. I've tried to set this up as best I can. But I get to the screen
Electronics Forum | Fri Jan 21 05:20:06 EST 2005 | Rob
Find out your maximum feeder loading (number of slots taken up, not number of feeders - 8mm, 16mm, 44mm, waffle packs tubes etc), and your likely long term max feeder loading (ie what is in the pipeline, or could be). Next find out your required run
Electronics Forum | Fri Jul 24 12:12:52 EDT 1998 | smd
200 boards/Hr and oven will reflow ~180 boards/Hr but the P&P machine will only place 700-950 CPH | | when setup is taken into account. Minimum pitch is normally .020" and we place an Avg. of 491 TSSOPs and 217 BGAs a month. | | We don't even bother
Electronics Forum | Fri Jul 24 16:02:13 EDT 1998 | Justin Medernach
200 boards/Hr and oven will reflow ~180 boards/Hr but the P&P machine will only place 700-950 CPH | | | when setup is taken into account. Minimum pitch is normally .020" and we place an Avg. of 491 TSSOPs and 217 BGAs a month. | | | We don't even bo
Electronics Forum | Thu Sep 19 11:14:45 EDT 2002 | Jim M.
We had lots of problems with bridging on 15.8mm pitch, QFP17-160 at the start.The board was .032 thick, double sided-six boards to a panel. Here is the problems (not neccessarily in the biggest to little but as i remember them) and solutions that he
Electronics Forum | Mon Apr 08 13:09:48 EDT 2013 | microaide
I have set Maximum Sequence Steps Per Program Segment to 450 and Maximum Placements Per Program Segment to 200. I have two Quad IVc machines, with a separate central controller in each one. One machine has a waffle feeder and will have vibratory feed
Electronics Forum | Wed Apr 08 18:15:18 EDT 1998 | Graham Naisbitt
Scott, I am not really in a position to answer this as fully as I would like because most military work with which I am familiar is subject to some degree of secrecy most especially on the internet. At least we have signed up to such restrictions. Ho
