Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Tue Mar 22 14:50:11 EDT 2016 | ttheis
A friend of mine has a used gsm1 but when loading up UPS it gives an error indicating it did not receive a request to load the machine model in the allotted time. Photo is attached of the message. Any suggestions what to look at? The machine is runni
Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Tue Mar 17 09:09:34 EDT 2020 | emeto
You should be able to operate/troubleshoot machine on its own. Not sure if you have to switch some key on the back to change the mode, or it will initialize on its own using the last program that has been loaded....it's been awhile. Line computer dow
Electronics Forum | Mon Mar 09 16:27:46 EDT 2020 | oxygensmd
Sadly, without line controller software you won't be able to load jobs to your machines. Check your mails later.
Electronics Forum | Mon Mar 09 14:16:37 EDT 2020 | oxygensmd
I used to work with S15/F3, was a 10 years ago. 1. Test your machine controllers and station controllers. Load the last program with actuell command. 2. You can check what happening in the SiPlace, switch the monitor to MC, let see all bootup perfec
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Mon Mar 09 16:22:05 EDT 2020 | sportsradar
Hello Kristof, We use 1 PC which does line control and programming. We always boot the PC up first, then when it is fully booted, then we turn the machine on, we let it zero set, then we send the job over (this is how we do it when everything works)
Electronics Forum | Thu Mar 05 23:04:44 EST 2020 | sarason
My advice for what it is worth. Your description of the problem at first glance suggests a communication problem, now is it the bus, the SMT machine or the PC. The bus could have a short or an open. The PC could have a dud controller card. or so co
Electronics Forum | Tue Mar 17 16:27:32 EDT 2020 | sportsradar
With LC off, the machine when told "Without LC" will zero set. It displays Error 746. After zero set, turn LC on, and it hangs up. Error 746 is IEC blocked, solutions Reboot machine and PC. And we know, rebooting isn't getting me anywhere. What car
winsouce.jpg)
