Electronics Forum | Mon Mar 09 13:07:52 EDT 2009 | rodrigo
Hi all, Our IP-2 stop working during production with a Servo NG error. Turning it on and off just goes back to the same thing or "Turn servo power on" error message. I was checking the power for the servo amps and I found a 35VAC line that is missin
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
Electronics Forum | Thu Feb 24 12:48:45 EST 2000 | Larry Johnson
I have seen this problem several times on several different IP3's... When the MTU is about to pick a part from the tray, the machine will just stop. No error, just says, "producting", in green. E-stop, reset and start again, and you hear air from
Electronics Forum | Thu Feb 24 12:48:45 EST 2000 | Larry Johnson
I have seen this problem several times on several different IP3's... When the MTU is about to pick a part from the tray, the machine will just stop. No error, just says, "producting", in green. E-stop, reset and start again, and you hear air from
| 1 |
