Electronics Forum | Mon Aug 02 08:58:43 EDT 2010 | kpm135
It's been a while but I believe the UP2000's should have a calibration for the squeegee height as well. I think you log in under the Calibrate or Maintenance then that should give you access to the menu you need. Once you find it I'm pretty sure it w
Electronics Forum | Sat Feb 02 09:53:49 EST 2019 | slthomas
Commponent pitch programming is performed via the buttons on the feeder. I don't remember enough to walk you through it but there are people here that do - I'm sure you'll get some help shortly. If not, go to http://www.precision-repairs and use th
Electronics Forum | Mon Jun 22 19:17:07 EDT 2020 | bmalhi
There are many things that can cause this and several solutions. Suggest having Heller Service Tech come in put some thermocouples at various points and determine the best course of action. If in-person visits are not possible at this time, we can wa
Electronics Forum | Thu May 11 20:48:14 EDT 2023 | johndep7
I have issues with damaging PCB with depaneling in my company. Mostly mousebite depaneling and some vscore. I have looked into laser depaneling, pneumatic, routers, hand tools but have not found something that I can put full trust in. To understand m
Electronics Forum | Wed May 10 12:13:16 EDT 2006 | scombs
We have a 6 up panel with a 1206 part .082" from the board scoreline. After depanelization when we run the board through ICT it fails for a short at that location. We have visually inspected at high magnification for any cracks in the body and at the
Electronics Forum | Wed May 10 13:03:50 EDT 2006 | PWH
It sounds like your depaneling method is good. The only thing left to look at is to see if the depaneler is hitting the part somehow from the cutter or the bottom plates. I've seen time and time again where an operator has a part in contact with th
Electronics Forum | Fri Jun 03 10:11:08 EDT 2016 | tnisbet
If you end up buying a depaneling machine/robot, > the guys at Pentagon EMS are very good at making > fixtures. Once they have the specifications of > your machine all you will have to send them is > your panelized drawing of your board. In extre
Electronics Forum | Wed Jun 13 17:50:06 EDT 2001 | deonn
Igmar, Have had similar problems in the past caused by different factors. The first obvious area to check is in your pick and place machine. Too much force in the Z-Direction may cause micro-cracks, which are not apparent, until the board is proces
Electronics Forum | Wed Jun 13 17:50:28 EDT 2001 | deonn
Igmar, Have had similar problems in the past caused by different factors. The first obvious area to check is in your pick and place machine. Too much force in the Z-Direction may cause micro-cracks, which are not apparent, until the board is proces
Electronics Forum | Mon Sep 28 09:58:45 EDT 2015 | ahanna
Hello everybody! I'm working with a Quad 4000c that has been refurbished by PPM and need a little help with using the CAD feature. Is there anyone that can help me out by giving me a basic walk through of how this works? I'm not sure if this is valu