Electronics Forum | Sun Oct 30 06:13:23 EST 2005 | mika
I am sorry for my poor english, but perhaps you will undertsand:-) The important thing is to get the conveyors straight: The front fixed rail must be parallel with the next one and also the heigt. The heihgt of the prior conveyour should be (but not
Electronics Forum | Fri Mar 24 08:10:12 EST 2006 | mapell
Hi AR Nice job on the chain/rail cleaning. I would contact Speedline Electrovert tech support, 800.737.8110 to assist in trouble shooting. They can walk you through using a meter to measure input and output current to the SC card and make sure tha
Electronics Forum | Mon Oct 02 10:22:13 EDT 2006 | SteveH
We are having issues with cleaning underneath leadless chip carriers due to their extreme low lying nature and I wondered if anyone else had any experience of this. Our process for years has been vapour degreasing with Triklone N, which works, but w
Electronics Forum | Tue Jan 05 21:01:40 EST 2021 | brianjones
We are looking at setting up a memory module conveyor belt with a stacker and de-stacker. I will need to handle DDR3 and DDR4 Long DIMM and SODIMM. I will be mounting an image camera under and over the modules. Looks like an edge conveyor would be be
Electronics Forum | Wed Dec 17 13:20:43 EST 2003 | fdr4prez
I was under the impression that PCT was bought out by one of their competitors, but I can't remember who. This was a couple years ago. You may need to call a few manufacturers, or do some more research to see who bought them.
Electronics Forum | Tue May 06 15:32:48 EDT 2008 | realchunks
IF and only IF you are on a solid flooring. We have ESD carpet. If you were to apply RTV to the carpet, you'd be walked out and thrown on your skinny a$$. Also, extruded aluminium conveyors will bow before skidding, thus causing alignment problems
Electronics Forum | Fri Mar 19 13:26:19 EST 1999 | Scott Cook
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Tue Sep 11 07:58:02 EDT 2007 | hussman
Does he look at the board under a Mantus and mistake vias for solder balls, get mad and walk away? Mine does.
Electronics Forum | Mon Aug 02 08:58:43 EDT 2010 | kpm135
It's been a while but I believe the UP2000's should have a calibration for the squeegee height as well. I think you log in under the Calibrate or Maintenance then that should give you access to the menu you need. Once you find it I'm pretty sure it w
Electronics Forum | Thu Jul 28 18:53:32 EDT 2011 | rway
Make sure your system is not in bypass mode (under conveyor setup). Also, the intermittent SMEMA signal can cause the conveyor to turn on until it times out. Check your sensor on the upstream conveyor. Cover it and check your diagnostics to ensure
winsouce.jpg)