Electronics Forum | Mon Sep 29 14:47:07 EDT 2008 | ikonify
Have seen similar problem before with regards the MSD being the cause. But also seen similar defects being found at functional test as the in-circuit test was injecting to much current during test. The devices were walking wounded afterwards. The in
Electronics Forum | Fri Sep 05 09:42:41 EDT 2014 | cflames17
If you call service they can also walk you through the motor test. Ask for Glen. Al no longer works for MYDATA.
Electronics Forum | Thu Mar 29 08:10:55 EDT 2007 | donjohnson
Thanks Dave... To all that took offence I do apologise, its a fine line that i'm walking here. Accelerated life testing is an integral part of todays development and manufacturing environment. I've spent 3 years living with 50% of my time in a desi
Electronics Forum | Thu Aug 26 21:54:57 EDT 2004 | KEN
I ran into this about 2 years ago. The Rework Operators (all 3 shifts) would rework a device, rince the board with tap water (yep, 50k / Cm^3) from a nearby sink, then send the PCB to test (which is really ironic as they had to walk past the DI wash
Electronics Forum | Wed Feb 14 14:11:17 EST 2007 | greg york
We have profiled hundreds of ovens here and it really is dependent on work going through, I walked in on one trial and was faced with an oven that was literally two foot long and told the guy it would not be suited only to profile and run lead free t
Electronics Forum | Fri May 09 09:25:24 EDT 2008 | russ
Hi Dave, we have thought about it, but would like to have something that we can use anytime we want, The dosimiter badges are good except they have to be sent in and then we wait for results. we have people here that are afraid to even walk in front
Electronics Forum | Wed Mar 24 12:34:33 EST 1999 | Scott McKee
| Hi, | I have a customer who's electronic assemblies produce RF. He is insisting upon aqueuos cleaning. We switched to a no clean solder years ago and no longer have an aqueous system. | Is aqueous cleaning necessary to eliminate 'cross talk' of
Electronics Forum | Fri Feb 13 11:22:17 EST 2015 | slarochellesmt
I can offer some background on the IINEO II as I feel it is much better than the Yamaha. I currently have 3 IINEO IIs in production that replaced 3 Assembleon lines. The IINEOs handle quick changeovers better than any SMT line that I have used to d
Electronics Forum | Thu Mar 25 19:29:07 EST 1999 | Graham Naisbitt
| | Hi, | | I have a customer who's electronic assemblies produce RF. He is insisting upon aqueuos cleaning. We switched to a no clean solder years ago and no longer have an aqueous system. | | Is aqueous cleaning necessary to eliminate 'cross ta
Electronics Forum | Mon Mar 29 19:31:29 EST 1999 | Scott McKee
| | | Hi, | | | I have a customer who's electronic assemblies produce RF. He is insisting upon aqueuos cleaning. We switched to a no clean solder years ago and no longer have an aqueous system. | | | Is aqueous cleaning necessary to eliminate 'cr
.gif)
.gif)