Electronics Forum | Wed Jan 20 13:07:16 EST 1999 | Robert Noory
I have received prototype PBGA (256 pins) devices from Motorola (actual part number = KXPC850ZT50). These parts seemed very warped on the edges. When I put the part on a plain surface, it rocks quite a bit when I press lightly on a corner. I have
Electronics Forum | Wed Jan 13 19:13:59 EST 1999 | Michael Allen
Just a comment: we've seen PBGAs curl up at the corners, but only on prototype components that came off of a low-volume "prototype" line at our component supplier's lab (non-production overmold material was used). Production parts have not exhibite
Electronics Forum | Wed Jan 20 20:42:08 EST 1999 | Tony A
| I have received prototype PBGA (256 pins) devices from | Motorola (actual part number = KXPC850ZT50). These parts seemed very warped on the edges. When I put the part on a plain surface, it rocks quite a bit when I press lightly on a corner. I h
Electronics Forum | Thu Jan 14 08:32:22 EST 1999 | Jim Nunns
They are supposed to be production parts. Our volumes are in the hundreds due to rapid change though. Jim Nunns | Just a comment: we've seen PBGAs curl up at the corners, but only on prototype components that came off of a low-volume "prototype"
Electronics Forum | Thu Jan 21 15:24:18 EST 1999 | Terry Burnette
| I have received prototype PBGA (256 pins) devices from | Motorola (actual part number = KXPC850ZT50). These parts seemed very warped on the edges. When I put the part on a plain surface, it rocks quite a bit when I press lightly on a corner. I h
Electronics Forum | Wed Jan 13 17:08:20 EST 1999 | Jim Nunns
I have some BGAs with a warped chip carrier. Some of the balls are tall like columns and some are short oval shapes. How can I determine when warpage will cuase failures from stress. Is there a spec out there from studies anyone has done? Any commen
Electronics Forum | Fri May 04 18:27:34 EDT 2001 | chpark
BGA warpage combined with PCB warpage can lead significant process yield loss. First, it is possible that major portion of BGA's apparent warpage is, in fact, coming from the PCB warpage. Assuming that the warpage is solely from BGA itself, I think
Electronics Forum | Sun Mar 07 19:58:03 EST 2004 | praveen
Hello , Can any body help in solving the problem of PCB warpage during BGA rework. I am using IR heating system. No problem found in reworking BGA's size less than 30mmx30mm but for 35 mmx35mm and above BGA get solder short due to PCB warpage. Note
Electronics Forum | Sun Aug 01 11:39:41 EDT 2004 | Andrew
I am seeing high rate of open joint at NexLev connector and also BGA warpage issue with 52 mm Hyper BGA.anyone has the same experience?
Electronics Forum | Wed May 02 12:12:23 EDT 2007 | SWAG
Restrictive carriers or lack of carrier in reflow can cause board warpage = bad for BGA's. Might be something to look at.
