Electronics Forum | Fri Jul 10 07:34:00 EDT 2020 | elijah
From the poor bonding strength of the board, the surface quality problems of the board are divided into: 1. The cleanliness of the board surface; 2. The problem of micro graphite (or surface energy) on the surface. PCB circuit board proofing Youke bo
Electronics Forum | Mon Jun 19 09:47:23 EDT 2017 | georgetruitt
You have a lot to think about! What does the flux manufacturer recommend as far as specifics like water temp or pressure? Do they recommend high temp di-water a detergent or saponifier? Do you currently have a cleaning machine, batch cleaner or inl
Electronics Forum | Wed Apr 12 21:04:10 EDT 2000 | Dave F
Ashok: You still didn�t tell me why you want additional drying of your boards, but what the hey, we all have our dark secrets. Anywho, let�s consider some options for reducing the moisture of your cleaned boards: OPTION 1 - Up-Grading Your Cleaner
Electronics Forum | Thu May 20 07:52:36 EDT 2010 | rgduval
In general, cleaning with deionized water is acceptable for most component. Open switches and contacts, in general, do not get damaged in this process. A good drying is required, of course, after washing. However, you've described dewetting issues
Electronics Forum | Tue Jul 01 21:40:04 EDT 2008 | davef
Vapor degreasing systems * Thermal Equipment [Baron-Blakeslee]; Torrance, CA; thermalequipment.com * Exselect Engineering; Concord, ON CAN; exselect.com * Branson Ultrasonics; Danbury, CT; bransoncleaning.com * Greco Brothers; Providence, RI; grecob
Electronics Forum | Tue Apr 11 17:45:02 EDT 2000 | Ashok Dhawan
I am looking for an appropriate method to dry wave soldered boards. While board assemblies are passed through board cleaning station , they are not fully dry . We do not want to heat above 180 deg F to dry them completely. We think that air drying u
Electronics Forum | Tue Apr 11 20:23:19 EDT 2000 | Dave F
Ashok: You're still goin' down that ol' ESD road aren't ya bud? Why do you need the boards to be dry? Conformal coating? Hey wait a minute, are you one of those no-clean people? Er zis related to the Kapton tape res fandango? Anywho, be careful
Electronics Forum | Sun Mar 28 22:17:36 EST 2004 | Grant Petty
Hi, I would also be interested in this thread, but our problem has a different twist to it. We have good results from our reflow with Koki no clean paste, however when we pass the boards through the wave solder machine, the flux in that leaves a fog
Electronics Forum | Wed Mar 31 21:08:34 EST 2004 | Ed
Hey guys. I've been manually dunking circuit boards for 8 years now. I too have the excess residue issue to contend with. I'm using a low solids - no clean flux from Kester (959). I have used solvents, thinners, windex and a multititude of cleane
Electronics Forum | Wed Sep 25 15:58:36 EDT 2002 | bschreiber
Hello Dave, I hope that electronic slap didn�t hurt too much. Robf, I am sorry that you did not agree with my initial response, but the answer is very detailed and most of the support material I have is only in paper format so I need to either snai
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900
