Electronics Forum | Wed May 30 18:44:06 EDT 2007 | binow
Various processes throughout the factory will use a stamp to signify ICT has been completed or QA has been done. The problem we are having is once the boards have made it through all the steps and have the stamps on them signifying who did what; the
Electronics Forum | Thu May 31 13:39:23 EDT 2007 | wavemasterlarry
You need to switch to an alcohol based stamp. It will work cause that's what we use.
Electronics Forum | Thu May 31 08:18:18 EDT 2007 | davef
The following make inspection stamps. They may be able to help: * VRS Marking; 567 Camino Mercado Ste. A, Arroyo Grande, CA 93420; 800-782-6790 805-481-9787 F800-743-3135 F805-474-1238 contactvrs@vrsmarking.com vrsmarking.com * Des Moines Rubber Sta
Electronics Forum | Thu Jun 24 21:37:13 EDT 2004 | davef
IPC / EIA J-STD-001-C, Appendix B
Electronics Forum | Tue Jun 29 06:43:05 EDT 2004 | davef
Look at: TP-1115 - Selection And Implemetation Strategy For A Low-Residue, No-Clean Process
Electronics Forum | Thu Jun 24 20:28:58 EDT 2004 | needhelp
We design PCBAs. Our CM assembles the boards for us. So far we have used waterwash SMT process to build the boards. Accidentally, due to documentation errors, we suddenly have a huge batch of boards built with No-Clean process. Although the boards pa
Electronics Forum | Wed May 25 18:33:18 EDT 2005 | russ
We have passed testing using this process, I would consider it on a case by case basis however. We are very careful about the quantity of the O.A. that we use. The water soluble flux is gone after cleaning unless it was/could be encapsulated or tra
Electronics Forum | Wed May 25 18:09:47 EDT 2005 | Fluxed_State_of mind
Need some input here..... The fear is that the if we use water soluble flux at the repair operation, that the no-clean encapsulation will capture some of the organic material as it cools down and goes to its original state. The organic material wil
Electronics Forum | Fri May 27 12:09:59 EDT 2005 | saragorcos
You do want to be very careful with potentially entrapped organic materials as they are prone to causing electrical leakage failures particularly around sensitive devices. There is a new clenliness testing tool available that tests a localized area
Electronics Forum | Sat Oct 04 00:21:00 EDT 2003 | Dean
It would help to run a carbon, anion, cation, mixed-bed configuration with pure DI as the final rinse. IF your incomming water is really bad you can run a RO unit to "prepare" the water for ion exchange. Do you run omega meter or ionograph testing
.gif)
