Electronics Forum: water chiller (Page 1 of 1)

NEED BTU MANUAL

Electronics Forum | Tue Jun 04 11:17:39 EDT 2019 | dman97

Does anyone have a manual for a BTU PYRAMAX 150N X5 oven? We recently got one of these used and it has the flux management system attached along with a water chiller. We hooked everything up, but the oven throws a water supply problem alarm. Chill

OMNIFLOW 10

Electronics Forum | Mon Sep 08 18:14:00 EDT 2003 | Brian W.

I had an Omni10 that was set up for nitrogen, but also required a water chiller. Make sure your oven wasn't set up to be run with one. If, it was, I know a couple places that sell chillers which will meet the requirements. Brian W.

Reflow Incoming Chilled Water Temp

Electronics Forum | Thu Jul 01 00:03:31 EDT 2010 | saukat

Hi.. I am optimizing the reflow oven temperature setting, Interested to know the ideal incoming chiller water temp. My machine is running lead-free process with the incoming chiller water at 12 degree C. Regards,

Chillers, Coolers

Electronics Forum | Tue Nov 30 14:29:52 EST 1999 | Jay Claybrook

Looking for information on portable chillers or coolers used with the water type recirculation heat exchanger cooling modules on the TRS21 BTU double furnace ovens. For use where you don't have a chilled water supply in the facility. Any info would

BTU paramax 150

Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy

This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I

Electrovert Bravo 8105 Cooling Zone Chiller

Electronics Forum | Thu Nov 18 16:09:12 EST 2004 | ms

Hi Everyone. Are many of you using Bravo 8105 reflow ovens with chiller units? What have your experience been like with them. Are they reliable? If you had the choice would you get another? Is having them an advantage with lead free production?

DEK Printer Chiller set up

Electronics Forum | Mon May 02 10:13:42 EDT 2016 | swag

If it's like ours, it's an AC unit, not a chiller. Easy to hook up with a hose to the printer + power to the unit. You'll need to empty the water from the drip pan from time to time (collects condensation).

Nitrogen gassing ring

Electronics Forum | Tue Mar 14 13:00:38 EDT 2017 | stephendo

I had a nitrogen salesman in yesterday. He brought his technical support person with him. He said he could add a pre-filter just before the machine regulator. I asked him about it and he said that if you get a pin-prick hole in your piping you can

DEK Printer Chiller set up

Electronics Forum | Tue May 03 14:55:50 EDT 2016 | sumote

If it is an ECU you will need power and water. It will keep temp and humidity at your setpoint. I have used them before and was not overly impressed with them. Your process requirements may be more stringent than mine was though. If you have very d

Foam fluxer maintenance, storage and cleaning

Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef

Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we

  1  

water chiller searches for Companies, Equipment, Machines, Suppliers & Information