Electronics Forum | Wed May 28 09:51:06 EDT 2008 | andrzej
Hi, what is minimal time for fluxer to prepare for fluxing another frame ? Is it possible to run through fluxer frame after frame without any spacing between them ? Thanks for any comments, Andrzej
Electronics Forum | Wed Jul 19 02:37:24 EDT 2017 | bukas
Hello everyone, i recently got Ersa ETS 330 wave machine '94. I got it running and heaters and flux pumps are ok, but I have problem with 2nd wave pump. It runs for 10-15 sec and then shuts down with error message on display. I checked bearings and
Electronics Forum | Thu May 14 13:10:59 EDT 2020 | bukas
Hello, anyone got a installation software for ERSA EWS330? Can it run on winXP? Thanks.
Electronics Forum | Tue Mar 29 06:12:59 EDT 2022 | bukas
Hi, i'm looking for someone with great knowledge of EWS 330 machine, 2005 yom. Main problem is that machine stops when PCB frame comes on second hall sensor of automatic fluxer.
Electronics Forum | Wed Nov 11 00:42:15 EST 1998 | Jason
Mike, We retrofitted all of our waves with USI spray fluxers. We are running no-clean on 4 of our waves, and OA 2331-ZX, reduced specific gravity to .825, on the other 2 With OA you must buy a special spray head to accomadate higher pressure and l
Electronics Forum | Thu Nov 16 12:52:04 EST 2017 | charliedci
We installed a SonoFlux ultrasonic spray fluxer, replacing the foam fluxer in our Electrovert Econopak wave in 2014. The cost at that time was 16K, installation included. We ran water based flux through it and as long as we kept it clean, worked well
Electronics Forum | Wed Aug 18 08:29:29 EDT 2004 | haris
hai all, can anyone tell me what is the abbreviation for ATS in ATS spray fluxer. Mail answer to manovah@yahoo.com with best regards, Haris Manovah
Electronics Forum | Thu Aug 19 16:28:54 EDT 2004 | davef
We don't know. "ATS Fluxer" is a SEHO product identification. So, check with your SEHO representative about the meaning of "ATS".
Electronics Forum | Thu Nov 16 07:57:48 EST 2017 | andras
Hi, I must change our current terrible foam fluxer unit used in Seho wave to a spray type to let able to use water soluble flux. Does anybody have recommendation for solution that won't break the bank? BR:Andras
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
