Electronics Forum | Mon Apr 19 11:36:10 EDT 2010 | baildl632
We installed a fixed distance optical sensor above the conveyor rail and "wired it" throught he machines terminal bus to cut the pump on only when a board was present at the pot. We also installed a timer in line so the pump would only stay on long e
Electronics Forum | Thu Apr 01 14:43:26 EDT 2010 | cbart
You say its in both smt and through hole, but, are you waving the SMT parts as well, I assume yes since you think its dross in the joints. Questions: 1- do you have higher mag scopes that you can zoom in a little more to see if these are voids or dr
Electronics Forum | Wed Sep 16 08:46:50 EDT 1998 | Chrys
Hi Folks, Need to draw upon the vast expertise in this forum... Whenever you fill a new wave solder machine with fresh bar solder, it seems to produce more than the normal amount of dross for a few weeks. I always understood this to be the solder "c
Electronics Forum | Fri May 18 04:40:51 EDT 2007 | gregoryyork
Wash them in Saponifier frequently at around 40C rinse and dry thoroughly. I would imagine it could be going white if you have a resin system in the flux that is not water soluble. Ensure you are using suitable pallet material up to 300C for Lead Fre
Electronics Forum | Fri Dec 02 05:06:11 EST 2016 | slavek
Hello, my question would be how often you clean the pot? The second picture with the particles looks for me like burned flux etc. When you took out a large quantity of solder dross, I think that big amount of it was released into system. Clean the
Electronics Forum | Sat Jun 02 08:17:58 EDT 2012 | saju86ece
Hi, I need to do the implement the new wave solder dross remover(model-DC9500)to wave soldering machine in our organization. In that i need detail action taken plan for implementation. Please suggest and give the detail information. 1.How to implem
Electronics Forum | Thu Jan 31 06:38:55 EST 2008 | cobar
Wave too high,pot temp to high set to 245�C. Solder level too low.
Electronics Forum | Thu Mar 23 13:48:07 EST 2000 | John Storjohann
A number of years ago I used a Kester product called Solder Saver. It is a thick liquid that one squirts onto the dross on a hot solder pot. It separates out the solder leaving a crust of almost clean dross. Unfortunately a mask is still required. Th
Electronics Forum | Sat Jun 02 16:20:06 EDT 2012 | davef
While the only way this thread could look more like a stealth advert is if it has the word 'advertisement' blinking at us, I'll play along. Questions are: * Have you asked the supplier Fantron Technologies [sales@fantron.com] what they suggest? * Wh
Electronics Forum | Tue Oct 14 07:22:05 EDT 2008 | ccouture
I use this directly in the solder pot inside the wave machine. It is small enough to float at the surface of the solder, yet by loading it it act as a sieve and retains the dross while most of the solder pass trough, allowing me to clean the whole po
